Twist Drill — Short Type N, 2.5 mm, 118°, TiN-coated HSS-G (DIN 338) by MetavCUT

The Twist Drill is a short Type N metalworking drill designed for precision drilling in alloys and steels with a 2.5 mm diameter and a 118° point angle.

• Short design for greater stability and precision
• TiN-coated surface for extended tool life
• Fully ground HSS-G for faster cutting and clean holes
• Conforms to DIN 338 for consistent quality
• Optimised for Drilling Machine applications

Precision and stability for demanding metalwork

The short geometry of this Twist Drill reduces the unsupported overhang, resulting in higher stability and less tendency to deflect under load. This design advantage makes it particularly suitable for precision work and for drilling in hard materials such as alloyed steel and tempered castings. The 118° point angle supports accurate centring on slightly convex surfaces and improves initial penetration, which is beneficial when accurate positioning is critical.

Longer lifetime through coating and material

A TiN-coated surface combined with HSS-G substrate reduces friction and wear during cutting, increasing service life under metalworking conditions. Titanium nitride lowers adhesion of chips and heat buildup, while the fully ground HSS geometry delivers sharper cutting edges and improved chip evacuation. Together these properties help maintain performance over many holes when used with appropriate cooling.

Faster drilling with lower feed force

The ground flute geometry of this short Twist Drill enables up to 40% faster drilling and requires significantly less axial force compared with conventional HSS types. This leads to smoother operation on both stationary and portable drilling machines and reduces operator fatigue. For best results, pairing the drill with suitable coolant or cutting fluid minimises thermal stress and preserves cutting geometry.

Application scope and recommended usage

Designed to meet DIN 338, this short Type N Twist Drill is intended primarily for metalworking tasks such as drilling in alloy and unalloyed steels, cast iron, sintered iron, non-ferrous metals and hard plastics. Use in a drilling machine with correct speeds and lubrication is advised. Because the drill is ground rather than rolled, expect very precise hole quality and good concentricity, while taking care to avoid excessive impact loading to prevent brittle fracture.

Strongly recommended: choose the MetavCUT Twist Drill for professional metalworking tasks and contact METAV Werkzeuge for tailored technical support — 📧 info@metav-werkzeuge.com | ☎️ +49 2822 7131930 | ✔️ WhatsApp +49 170 2837271

• Twist Drill
• Brand: MetavCUT
• SKU: 46025-FDA
• Diameter: 2.5 mm
• Overall length: 57 mm
• Spiral length: 30 mm
• Point angle: 118°
• Type: Type N
• Execution: Short
• Shaft design: Fully ground
• Material: HSS-G
• Coating/Colour: TiN-coated
• Application: Drills for metal / Drilling Machine
• Model series: Standard Line
• Standard: DIN 338
• Manufacturer: Metav Werkzeuge GmbH; Parkring 45; 46446 Emmerich; Germany; info@metav-werkzeuge.com

FAQ

What is a Twist Drill used for and which materials suit this MetavCUT Twist Drill Type N?
The MetavCUT Twist Drill Type N is used mainly for drilling metal; it is especially suited to alloyed and unalloyed steel, cast iron, sintered iron, non-ferrous metals and hard plastics. Its short construction and HSS-G substrate make it appropriate for precise metalworking where stability and hole quality are priorities.

Which three drill types exist and how does the Twist Drill compare?
The three common drill types are metal drills, wood drills and masonry/concrete drills. The MetavCUT Twist Drill belongs to the metal drill category and is optimised for metalworking, offering sharper ground geometry and TiN coating compared with general-purpose wood or masonry drills.