35 mm Limit Go/No-Go Plug Gauge H7 Hardened Gauge Steel DIN 2245 - Metav IndustryLine

Take advantage of the combination of DIN 2245 conformity, hardened gauge steel and a precise H7 fit to secure repeatable in-process inspection. Order the gauge directly via Metav Werkzeuge or consult our specialists for application advice.

M314.035 Limit Plug Gauge – 35.0 mm (DIN 2245, H7) by Metav IndustryLine

The M314.035 is a limit plug gauge designed to verify internal diameters to DIN 2245 with an H7 tolerance, suitable for workshop and production quality control.

• DIN 2245 standard, H7 tolerance
• Hardened gauge steel construction
• Precision ground 35.0 mm diameter

Reliable inspection for production control

A dedicated limit plug is the most direct way to confirm whether a bore meets a specified tolerance band. The M314.035 functions as a simple go/no‑go check: the H7 fit checks compliance to the stated hole tolerance in one quick step, reducing inspection time and avoiding lengthy measuring procedures. Because the gauge is manufactured to DIN 2245, it delivers a standardised verification method that integrates seamlessly into routine quality control and first‑off inspections, improving throughput and lowering the risk of downstream rejects.

Robust construction for repeatable measurements

Built from hardened gauge steel, the device is designed for long service life under frequent handling. The precision ground 35.0 mm shank resists wear and maintains dimensional integrity, which supports consistent pass/fail decisions over many cycles. The construction emphasises stability and resistance to surface damage; this translates into fewer replacements and a predictable inspection budget. For production environments where reproducibility is paramount, the mechanical simplicity of a limit plug offers a reliable complement to dimensional measuring instruments.

Traceability and process documentation made straightforward

The gauge provides an uncomplicated route to traceable checks within a production chain. Marking and SKU identification allow audits to reference the exact master used in inspections. Use of a standardised plug gauge shortens documentation time for quality records and helps demonstrate compliance during internal audits or customer inspections. When traceable certification or specific calibration status is required, Metav Werkzeuge can advise on the available options and accompanying documentation to meet process control needs.

Contact Metav Werkzeuge for supply and technical guidance on the M314.035 limit plug gauge, supplied from our Emmerich hub and supported by our inspection specialists

Technical Data

• Article number: M314.035
• GTIN: 4054469121635
• Manufacturer: Metav IndustryLine

Facts

• Diameter: 35.0 mm
• Standard: DIN 2245
• eClass: 21170218
• Tariff number: 90173000

Special features

• Material: hardened gauge steel
• Tolerance: H7
• Category: Limit plug gauge / Lehre

FAQ

What does the H7 tolerance indicate for this gauge?
The H7 designation identifies the tolerance band against which the M314.035 limit plug gauge is set; it defines the acceptable bore size range so a quick go/no‑go verification can be performed.

Is the M314.035 suitable for serial production checks?
Yes, the robust, hardened‑steel construction and DIN 2245 conformity make the M314.035 well suited to repeated in‑process checks in serial production.

How is the M314.035 identified for traceability?
Identification is possible via the Article number M314.035 and GTIN 4054469121635; these references allow audits to document which master gauge was used during inspection.

Manufacturer / Responsible: Metav Werkzeuge GmbH; Parkring 45; 46446 Emmerich; Germany; +49 2822 7131930; info@metav-werkzeuge.com