M14x0.75 Thread Go/No-Go Plug Gauge Right-Hand Metric ISO 6H Hardened Gauge Steel - Metav IndustryLine

Reliable inspection of M14×0.75 metric fine threads through a compact, hardened gauge-steel design delivering repeatable acceptance checks; the plug meets DIN 13, 6H and handles right‑hand threads with minimal wear. Order the thread limit plug directly via Metav Werkzeuge or ask our consultants if needed.

M315.014.3 Thread limit plug — M14 x 0.75 (DIN 13, 6H) · Metav IndustryLine

The M315.014.3 is a hardened gauge-steel thread limit plug for verification of M14×0.75 metric ISO fine threads, right‑hand, designed for workshop and inspection use

• Hardened gauge-steel construction
• Conforms to DIN 13, 6H
• Compact 0.1 kg for easy handling
• Right-hand metric fine thread M14×0.75

Consistent acceptance checks for fine threads

A purpose-built thread limit plug offers an immediate, objective decision at the inspection point: acceptable or out of tolerance. With designation M14×0.75 and compliance to DIN 13, 6H, this plug gauge provides a defined limit standard that supports reproducible acceptance in incoming inspection and final quality control. The measured geometry directly corresponds to the ISO fine-thread profile, reducing interpretation effort and accelerating go/no-go decisions on small‑pitch threaded components.

Durable construction for repeatable measurements

Constructed from hardened gauge steel, the gauge is dimensionally stable under normal workshop conditions and resists premature wear that would otherwise undermine inspection repeatability. Its compact mass of 0.1 kg and slim form factor make handling straightforward at the test bench or on the shop floor; the low weight aids rapid tactile assessment without compromising stiffness. These material and form choices reduce downtime caused by frequent replacements and simplify routine verification tasks.

Practical use in production and quality workflows

The plug is intended for right‑hand metric fine threads and suits batch sampling, assembly checks and spot inspections where a quick acceptance verdict is required. When used as part of a documented inspection routine, the gauge complements torque and fit control by verifying the internal thread form against an established limit. Its clear nominal designation and standard conformity support traceable documentation and easier integration into existing quality plans and production control routines.

Choose Metav IndustryLine thread limit plugs for reliable, repeatable thread inspection — contact Metav Werkzeuge in Emmerich for availability and expert advice.

Technical data

• Article number: M315.014.3
• GTIN: 4054469122427
• Customs tariff: 90173000

Facts

• Thread: M14 x 0.75
• Weight: 0.1 kg
• Standard: DIN 13, 6H
• ECLASS: 21170235

Special features

• Material: hardened gauge steel
• Right-hand metric fine thread
• Category: gauges / plug gauges
• Suitable for workshop and inspection use

FAQ

What thread size does this gauge check? This plug gauge verifies M14×0.75 metric ISO fine threads; the M315.014.3 is specified for this nominal and pitch.

Does the gauge meet a recognised standard? Yes, the M315.014.3 is manufactured to conform with DIN 13, 6H, providing a standardised acceptance criterion for inspection.

What material is the gauge made from and why does it matter? The gauge is made from hardened gauge steel to ensure dimensional stability and resistance to wear, which sustains repeatable acceptance checks.

Is this plug suitable for production sampling and final inspection? The design and conformity to DIN 13 make it appropriate for both routine production sampling and final quality inspections of metric fine threads.

How is the right‑hand designation relevant? The plug is manufactured for right‑hand thread forms; this ensures correct profile engagement and prevents misleading results when checking standard right‑hand metric threads.

Manufacturer / Responsible: Metav Werkzeuge GmbH; Parkring 45; 46446 Emmerich; Germany; +49 2822 7131930; info@metav-werkzeuge.com