5mm Test Pin Set 100‑Piece 70mm Length 0.01mm Graduation Special Steel, Plastic Case - Metav IndustryLine

Benefit from precise incremental checking across the critical 4.00–5.00 mm range, combined with fine 0.01 mm gradation and robust special steel construction for reliable, repeatable inspection. Supplied ready for workshop use in a protective transport case — order directly via Metav Werkzeuge or consult our specialists for application advice.

Gauge Pin Set M318.854 — 4.00–5.00 mm range, 0.01 mm increments, Metav IndustryLine

A Gauge Pin Set M318.854 engineered for precise clearance and plug inspection in toolmaking, workshop metrology and production quality control.

• 100-piece set for incremental checking
• 4.00–5.00 mm coverage with fine steps
• 0.01 mm graduation for precise tolerances
• Supplied in protective transport case

Accurate fit checking that prevents rework

The set delivers consistent precision across the narrow but critical 4.00–5.00 mm span, using finely graduated pins with 0.01 mm steps to identify deviations that would otherwise escape coarser gauges. Each 70 mm pin is manufactured from special steel to maintain geometry under repeated use, so tolerance deviations are detected early and corrective action can be taken before parts progress down the line. This reduces scrap and rework costs while supporting a stable production flow.

Robust handling and safe storage for everyday workshop use

Built for daily operation, the pins combine wear-resistant material with a practical length that reaches into blind bores and recessed features. Supplied in a protective transport case, the set is easy to organise and reduces handling time during inspection rounds. The material choice and finish ensure lasting contact surfaces; the result is dependable repeatability when performing quick go/no-go checks or match-fitting mating parts in assembly and toolroom settings.

Streamlined inspection that speeds decision-making

With finely stepped increments, selection of the nearest-fitting pin becomes immediate, shortening measurement cycles compared with iterative caliper checks. The set therefore supports faster quality decisions at incoming inspection, during setup or inline sampling. Where traceable documentation is required for process validation, Metav can advise on suitable calibration options and complementary measuring equipment to integrate the set into established quality procedures.

Discuss application needs with Metav Werkzeuge to confirm suitability for specific parts and inspection plans, and secure a Metav IndustryLine gauge pin set for consistent, workshop-ready checking.

Technical data

• Article number: M318.854
• GTIN: 4054469182063
• Material: Spezial-Stahl
• Length: 70 mm

Facts

• Measurement range: 4.00–5.00 mm
• Graduation: 0.01 mm
• Weight: 2.49 kg
• Set type: plug/gauge pin set

Special features

• Supplied in a protective transport case
• Designed for plug and clearance inspection
• Suitable for toolmaking and production quality control

FAQ

Which sizes are covered by the set? The set covers the 4.00–5.00 mm range in 0.01 mm increments, allowing fine selection of the nearest-fitting pin for clearance checks.

What is the length of the individual pins? Each pin measures 70 mm in length, giving sufficient reach for recessed bores and many common inspection tasks.

What material are the pins made from? The pins are manufactured from special steel, chosen for wear resistance and dimensional stability under routine use.

Is the set delivered ready for use in the workshop? Yes, the gauge pin set is supplied organised in a protective transport case, ready for immediate inspection tasks and safe storage.

Can this set be used for go/no-go and match-fitting operations? The fine 0.01 mm gradation and robust pin geometry make the set well suited for both go/no-go verification and precise match-fitting during assembly.

Manufacturer / Responsible: Metav Werkzeuge GmbH; Parkring 45; 46446 Emmerich; Germany; +49 2822 7131930; info@metav-werkzeuge.com