5.68mm Gauge Pin, ±0.001mm, Length 50mm, Workshop Version, Special Steel, Supplied In Case - Metav IndustryLine

Take advantage of the combination of workshop-grade robustness, ±0.001 mm dimensional precision and a compact 50 mm length for reliable end‑dimension checks; order directly via Metav Werkzeuge or consult our specialists for application advice.

Gauge pin M323.568 — precision 5.68 mm, ±0.001 mm (Metav IndustryLine)

A gauge pin designed for straightforward end‑dimension inspection and plug‑gauge tasks, specified at 5.68 mm diameter with a 50 mm length for checks in deeper bores.

• Workshop version for robust use
• Diameter 5.68 mm ±0.001 mm
• 50 mm length for deep bores
• Delivered in protective transport case

Consistent measurement where repeatability matters

A compact inspection pin with a specified tolerance of ±0.001 mm supports repeatable pass/fail checks and close‑fit verification in assembly and quality control. The very fine tolerance reduces uncertainty when establishing final dimensions on mating parts, enabling faster decision making on production lines and during set‑up. A clearly defined diameter of 5.68 mm makes the component suitable for comparison against drawing limits and for use as a reference in gauging fixtures.

Built for workshop use and long service life

Constructed from special steel, this workshop‑specification pin balances surface hardness and resistance to wear without unnecessary brittleness. The workshop version designation indicates components intended for daily handling and transport; the pin arrives in a protective transport case to prevent damage and to keep inspection tools organised. The modest mass supports easy handling for bench testing while preserving the stiffness required for accurate contact measurement.

Practical integration in inspection procedures

Designed as a single, purpose‑built inspection element, the pin integrates simply into existing gauging sets and plug‑gauge assemblies. Its 50 mm overall length is intended for checks in deeper bores or for reach beyond flanges where short pins would not suffice. Weight and compact form factor allow quick interchangeability in hand‑held routines or fixture checks, streamlining throughput and reducing non‑productive time in routine quality loops.

Choose Metav IndustryLine precision—contact Metav Werkzeuge for tailored advice and assured supply from Emmerich: info@metav-werkzeuge.com / +49 2822 7131930

Technical data

• Article number: M323.568
• GTIN: 4061905058394
• Category: Messstifte

Facts

• Diameter: 5.68 mm
• Tolerance: ±0.001 mm
• Length: 50 mm
• Weight: 0.013 kg

Special features

• Material: Special steel
• Workshop version
• Delivered in protective transport case
• ECLASS: 21170231

FAQ

What is the stated precision of the gauge pin?
The M323.568 gauge pin is specified with a tolerance of ±0.001 mm, suitable for precise end‑dimension checks.

What material is used for the pin?
The pin is made from special steel, selected for durability and surface integrity under repeated contact.

What are the diameter and length of the pin?
Diameter is 5.68 mm with a 50 mm overall length, designed for measurements in deeper bores.

Is the pin supplied in protective packaging?
Yes, the M323.568 is delivered in a protective transport case to prevent damage during storage and transit.

What applications is this pin intended for?
Typical uses include final‑dimension verification, plug‑gauge complements and inspection tasks in workshop and assembly contexts where tight tolerances must be verified.

Manufacturer / Responsible: Metav Werkzeuge GmbH; Parkring 45; 46446 Emmerich; Germany; +49 2822 7131930; info@metav-werkzeuge.com