7.38mm Gauge Pin ±0.001mm Length 50mm Workshop Finish - Metav IndustryLine

Take advantage of the combination of ultra‑fine 1 µm tolerance, robust special steel construction and a compact 50 mm working length for consistent final‑dimension checks; order the item directly via Metav Werkzeuge or consult our specialists for suitability in specific inspection tasks

Gage pin M323.738 — 7.38 mm, ±0.001 mm, length 50 mm (Metav IndustryLine)

The Gage pin M323.738 is a single precision test pin for final inspection and verification of bores, gauges and fixture alignment in workshop environments

• Workshop version for everyday inspection
• Diameter 7.38 mm with ±0.001 mm tolerance
• Length 50 mm for compact reach
• Made from special steel for durability

Reduce rejects with repeatable 1 µm accuracy

A tolerance of ±0.001 mm corresponds to 1 µm, a level of precision that turns routine checks into reliable evidence for dimensional conformity. The test pin is manufactured to tight limits so that reference checks, go/no‑go evaluations and comparative measurements become repeatable steps in an inspection routine. This degree of accuracy reduces rework and supports quality assurance processes by giving a stable benchmark for pass/fail decisions.

Durable design made for workshop handling

The workshop‑oriented construction uses special steel to balance wear resistance and machinability, providing a long service life under frequent handling. At 50 mm overall length the pin offers a compact reach suited to small‑bore checks and fixture alignment while remaining easy to handle. The single‑item supply simplifies inventory for specific replacement needs and supports immediate use in bench jigs or pin gauges without additional preparation.

Fits into standard inspection workflows with clear identification

Supplied as a single precision test pin, the component integrates with established checking procedures for final dimensions and end‑mass verification. The product carries GTIN 4061905061141 for traceability and stock management. Because the specification concentrates on a single diameter of 7.38 mm and a sub‑micrometre tolerance, it is particularly useful where precise mating fits or reference pins are required rather than broad‑range gauge sets.

Contact Metav Werkzeuge today for application advice or to secure Metav IndustryLine gage pins with 1 µm tolerance — eMail: info@metav-werkzeuge.com, Tel: +49 2822 7131930

Technical Data

• Article number: M323.738
• GTIN: 4061905061141
• Category: Gage pin
• Manufacturer: Metav IndustryLine

Measured values

• Diameter: 7.38 mm
• Tolerance: ±0.001 mm
• Length: 50 mm
• Weight: 0.021 kg

Special features

• Workshop version
• Material: special steel
• Single item supply
• ECLASS: 21170231

FAQ

What is the exact tolerance of this gage pin?
The gage pin M323.738 is specified with a tolerance of ±0.001 mm, equivalent to 1 µm.

Which material is used for the test pin?
The Metav IndustryLine gage pin is made from special steel to ensure durability under regular workshop use.

Is the pin supplied as a set or individually?
This item is supplied as a single precision test pin; it is intended for individual replacement or specific application use.

For which inspection tasks is this pin suitable?
The pin is designed for final inspection tasks such as bore verification, gauge checks and fixture alignment where a 7.38 mm reference and 1 µm accuracy are required.

How should the gage pin be stored to maintain accuracy?
Store the pin in a dry, clean environment and protect it from impacts; avoid prolonged exposure to corrosive agents to preserve the dimensional stability of the special steel.

Manufacturer / Responsible: Metav Werkzeuge GmbH; Parkring 45; 46446 Emmerich; Germany; +49 2822 7131930; info@metav-werkzeuge.com