7.63mm Test Pin, Single, ±0.001mm Accuracy, Length 50mm, Workshop Version - Metav IndustryLine

A compact inspection solution that combines ultra-fine accuracy with a durable workshop finish: the gauge pin delivers ±0.001 mm tolerance on a 7.63 mm diameter and a 50 mm length, ensuring reliable end‑measurement checks and reduced rework. Order directly via Metav Werkzeuge or consult our specialists for application advice.

Gauge pin M323.763 — single inspection pin, 7.63 mm, ±0.001 mm

The Gauge pin M323.763 is a single precision inspection pin intended for accurate end‑measurement and plug checks in workshop and assembly environments.

• Tolerance ±0.001 mm
• Diameter 7.63 mm
• Length 50 mm
• Workshop version with transport case

Reduce rejects with verifiable high precision

Accuracy is the primary value of this inspection pin: with a tolerance of ±0.001 mm on a 7.63 mm diameter, the component enables fine end‑measurement tasks where fit and runout matter. Such precision translates into fewer assembly mismatches and less rework, improving throughput and lowering scrap rates. The pin is engineered for dimensional stability; its finished diameter is suited for plug checks, end‑face verification and reference measurements in quality control processes.

Built for workshop durability and repeatable checks

Manufactured from special steel, the probe offers a balance of wear resistance and stable dimensions under regular shop use. The 50 mm length gives enough engagement for most fixture and bore verifications while remaining easy to manoeuvre in confined setups. The workshop version finish provides practical robustness without compromising measurement integrity, and the single‑piece supply supports straightforward replacement or supplementation within an inspection set.

Practical handling, traceability and supply confidence

Delivered as a single piece in a transport case, the pin is protected in transit and ready for immediate use at the bench; the case also simplifies storage between shifts. The compact format makes it ideal for end‑measurement routines and spot checks on production lines. Backed by Metav’s European logistics and product selection, the item supports predictable replenishment and a clear supply chain for small but critical measurement tools, offering both operational reassurance and an accessible route to precision.

Contact Metav Werkzeuge for tailored advice and secure the M323.763 gauge pin as a reliable tool for precise end‑measurement checks.

Technical data

• Article number: M323.763
• GTIN: 4061905061547
• Weight: 0.022 kg
• Material: special steel
• Diameter: 7.63 mm
• Length: 50 mm
• Tolerance: ±0.001 mm

Facts

• Single piece delivery
• SKU: M323.763
• Category: Gauge pin / inspection pin
• Story trigger: end measurements

Special features

• Workshop version finish
• Delivered in transport case (plastic or wooden case for transport)
• Suitable for plug checks and end‑face verification

FAQ

What inspections is this gauge pin suitable for?
The gauge pin is intended for end‑measurement and plug checks; the 7.63 mm diameter and ±0.001 mm tolerance make it suitable for precise fit and bore verifications.

Is the material corrosion‑resistant?
The pin is made from special steel designed for workshop use; for increased corrosion resistance, additional protective care or coatings should be considered depending on the environment.

Can this pin be used as a reference in fixture set‑ups?
Yes, the combination of a stable 50 mm length and tight tolerance supports repeatable reference points in fixture and assembly checks.

How is the pin supplied and protected?
The item is supplied as a single piece and delivered in a transport case to protect the probe during shipment and storage.

Manufacturer / Responsible: Metav Werkzeuge GmbH; Parkring 45; 46446 Emmerich; Germany; +49 2822 7131930; info@metav-werkzeuge.com