400mm Machine Saw Blade HSS Bimetal 32mm Width 2mm Thick 8.5mm Bore 10 TPI Staggered Teeth - TECWERK

Take advantage of a vacuum-hardened HSS bimetal construction and 10 TPI tooth configuration for reliable, long-lasting cutting performance; combined with a 32 mm blade width and 8.5 mm centre bore, this tool supports precise mounting and versatile application. Order the blade directly via Metav Werkzeuge or consult the team for technical guidance.

TECWERK machine saw blade L400 x 32 x 2 mm (HSS bimetal) – 10 TPI, 8.5 mm bore

A TECWERK machine saw blade designed for general-purpose cutting across many materials on industrial saws and production lines.

• HSS bimetal, vacuum-hardened blade
• 10 TPI for versatile cutting
• 8.5 mm centre bore for standard arbors
• 400 mm length aligns with hole spacing

Consistent cutting performance and extended service life

This blade’s HSS bimetal construction and vacuum-hardened treatment deliver a balance of wear resistance and edge toughness that reduces frequent replacements and downtime. The bimetal design bonds a high-speed steel cutting edge to a spring steel body, which provides resilience under load and maintains sharpness over extended runs. For workshop managers seeking measurable productivity improvements, the combination of durability and predictable life span supports more efficient planning and fewer unscheduled changes.

Accurate fitment and reliable run quality

With a 400 mm overall length and an 8.5 mm centre bore the blade matches common machine arbors; the 32 mm blade width and 2 mm thickness help preserve stability during cuts. The set (staggered) teeth and 10 TPI layout contribute to controlled chip formation and reduced vibration, which improves surface finish and reduces strain on the saw drive. These characteristics make the blade suitable for repetitive cutting tasks in production shops where consistent, clean cuts are required.

Versatility across materials with straightforward handling

Marked as suitable for cutting a wide range of materials, the blade’s geometry and 10 TPI tooth spacing enable efficient severing of both softer and harder stock without complex setup changes. The specification that length equals hole spacing facilitates straightforward replacement and inventory management; a single variant can cover multiple machines with the same arbor configuration. Maintenance remains simple: inspect tooth condition regularly and replace the blade when edge wear begins to affect cut quality rather than attempting repeated regrinding.

Contact Metav Werkzeuge for technical advice and reliable supply of TECWERK HSS bimetal machine saw blades directly from Emmerich

Technical data

• Article number: 2000814492NW
• Product type: Machine saw blade
• Brand: TECWERK

Facts

• Length: 400 mm
• Width: 32 mm
• Thickness: 2 mm
• Bore diameter: 8.5 mm
• Teeth: 10 TPI

Special features

• HSS bimetal material
• Vacuum-hardened
• Teeth set (staggered)
• Length corresponds to hole spacing
• Pack quantity: 1

FAQ

Which materials can this blade cut effectively?
The TECWERK machine saw blade with HSS bimetal construction is specified for cutting a broad range of materials; its vacuum-hardened edge is intended to offer good wear resistance across typical workshop materials.

What does 10 TPI mean for cutting performance?
A 10 TPI tooth arrangement provides a compromise between fast stock removal and acceptable finish; the 10 TPI layout on this blade suits mixed-material production where versatility is prioritised.

Will this blade fit my saw’s arbor?
The blade has an 8.5 mm centre bore; compatibility depends on the machine’s arbor diameter and any required bushings, so confirm arbor measurements against the SKU 2000814492NW before ordering.

Manufacturer/Responsible: NORDWEST Handel AG, Robert-Schuman-Straße 17, 44263 Dortmund