600 x 330mm Fitters Angle 30 x 5mm Without Stop - TECWERK

Take advantage of the combination of precise right‑angle referencing, a rigid cross‑section and flexible handling for dependable layout work. Order the TECWERK L‑shaped machinist's square directly via Metav Werkzeuge or ask the consultants for application advice.

TECWERK L‑shaped machinist's square 600 x 330 mm — L‑leg layout, supplied without stop

The TECWERK L‑shaped machinist's square 600 x 330 mm is a workshop layout and inspection tool designed for clear perpendicular referencing in fabrication, assembly and inspection tasks, supplied without a fixed stop to allow unobstructed placement along component edges.

• L‑shaped legs 600 x 330 mm
• Cross‑section 30 x 5 mm
• Supplied without stop

Accurate right‑angle referencing for layout and fabrication

The TECWERK L‑shaped machinist's square 600 x 330 mm provides a defined datum for large‑scale marking and assembly operations where predictable perpendicular lines are essential. The specified leg lengths (600 x 330 mm) permit measurements and scribe lines to be transferred across extended surfaces without repeated repositioning. Using clear geometric dimensions as a reference reduces the need for temporary fixtures and speeds up setup, which in turn supports consistent throughput in batch tasks.

Consistent stability from a controlled cross‑section

A cross‑section of 30 x 5 mm contributes directly to the tool's resistance to bending and torsion during manual use. This controlled profile concentrates stiffness along the legs so that the reference edge remains true when pressed against a workpiece for scribing or inspection. The result is improved repeatability, fewer measurement deviations and less corrective rework, which benefits production environments that depend on predictable part alignment.

Flexible handling and straightforward workshop integration

Supplied without stop, this machinist's square permits unobstructed sliding and placement, making it suitable for irregular edges and non‑standard workpieces where a fixed stop would be restrictive. The absence of a stop also simplifies storage and allows easier access when the square is used as a long straight edge. For additional technical information or measurement guidance, Metav Werkzeuge provides application advice and product details; general enquiries can be sent to info@metav-werkzeuge.com or made by phone on +49 2822 7131930.

For reliable right‑angle referencing and expert advice on the TECWERK L‑shaped machinist's square, contact Metav Werkzeuge for ordering and application support.

Technical Data

• SKU: 2000858060NW
• Label: Schlosserwinkel Schenkel-L.600x330mm o.Anschlag TECWERK
• Product type: Schlosserwinkel
• Manufacturer: TECWERK

Facts

• Leg lengths: 600 x 330 mm
• Cross‑section: 30 x 5 mm
• Pack unit: 1

Special features

• Supplied without stop (ohne Anschlag)
• L‑shaped layout for extended surface referencing

FAQ

What applications are this square suitable for? The TECWERK L‑shaped machinist's square 600 x 330 mm is suitable for layout, scribing and inspection tasks in metalworking and general workshop operations where clear perpendicular referencing is required.

How does the cross‑section affect performance? A 30 x 5 mm cross‑section increases stiffness along the legs of the square, so the TECWERK square maintains a truer right angle under hand pressure and reduces measurement variability during marking.

Can the square be used on irregular workpieces? Yes, supplied without a stop, the machinist's square allows unobstructed placement and sliding along edges, making it adaptable to non‑standard or irregular components.

Is the SKU available for ordering or reference? The product is listed under SKU 2000858060NW, which can be quoted when requesting product information or placing an order via Metav Werkzeuge.

Manufacturer/Responsible: NORDWEST Handel AG, Robert-Schuman-Straße 17, 44263 Dortmund