60×120cm Angle Measuring Device 0-270° Range, Long Legs - STABILA

Take advantage of the combination of a wide 0–270° measuring range and long 60 x 120 cm arms for efficient inspection of large components; the robust STABILA design supports consistent, repeatable angle checks. Order the WINKELSTAR directly via Metav Werkzeuge or consult our specialists for precise application advice.

WINKELSTAR angle measuring device by STABILA — 0–270° range, 60 x 120 cm arms

The WINKELSTAR is an angle measuring device for workshop and site use, built to check and set angles up to 270° on large components with long, rigid arms.

• 0–270° measuring range for wide angle checks
• 60 x 120 cm rigid arms for large workpieces
• STABILA build for stability and repeatability

Faster inspection of large parts through an extended measuring range

The combination of a 0–270° measuring range and long arm length significantly reduces the need to reposition components during inspection. This increases throughput in production and repair workflows by limiting setup time and potential handling errors. The extended range enables checks beyond a simple flat or right-angle measurement, which is particularly useful when working on complex assemblies or irregular geometries. The clear numeric span simplifies planning of sequential checks and supports a rational measurement routine in small and medium-sized workshops.

Stable construction for repeatable results and fewer rechecks

A rigid arm geometry and purpose-built angle mechanism provide stability and consistent contact with the workpiece, which translates into improved repeatability across successive measurements. Repeatable setups reduce scrap and rework and support quality control documentation. For teams that integrate angle verification into production steps, the sturdy configuration helps maintain alignment under modest handling, ensuring a reliable baseline for further machining or assembly tasks without introducing excessive measurement uncertainty.

Designed to integrate into workshop metrology workflows

The instrument suits carpentry, metalworking and general maintenance contexts where larger parts require quick, reliable angle verification. Supplied as a single unit, it can be stored with minimal fuss and incorporated into existing inspection routines. Clear labelling and straightforward geometry make it easy for trained staff to include angular checks in final inspection processes, helping to avoid assembly errors and ensuring components meet design intent. For procurement, the device is a practical choice when the emphasis is on efficient angle control and consistent results.

Contact Metav Werkzeuge for tailored advice on integration and to secure a STABILA WINKELSTAR directly from our Emmerich facility on the Rhine

Technical Data

• SKU: 4000857625NW
• Type: WINKELSTAR
• Product: Winkelmessgerät
• Brand: STABILA
• Label: Winkelmessgerät WINKELSTAR Messber.0-270Grad Schenkel-L.60x120cm BMI

Facts

• Measuring range: 0–270°
• Arm dimensions: 60 x 120 cm
• Packaging unit: 1

Special features

• Large-range angle measurement
• Long, rigid arms for large workpieces
• Identifier: 4000857625NW
• Additional reference: 0-270: 4000 857 630

FAQ

What angles can be measured with this instrument?
The device covers a 0–270° range, enabling checks from flat to obtuse angles without frequent repositioning.

What are the arm dimensions of the angle gauge?
The gauge features arms of 60 x 120 cm, suitable for larger components and assemblies.

Is the instrument intended for workshop use on large components?
Yes; the long, rigid arms and wide measuring range make the product suitable for measuring and setting angles on larger workpieces typically found in workshops.

How is the product identified for ordering or inventory?
The item is listed under SKU 4000857625NW and does carry the label information shown in the product data.

How is the device supplied?
The product is supplied as a single unit (packaging unit: 1), ready for integration into existing inspection routines.

Manufacturer / Responsible: Metav Werkzeuge GmbH; Parkring 45; 46446 Emmerich; Germany; +49 2822 7131930; info@metav-werkzeuge.com