70 x 200 mm Angle Column 90° Ground Base and Shaft, Accuracy 0.005 mm - Metav IndustryLine

Take advantage of the combination of 0.005 mm accuracy, a hardened special steel construction and a ground reference face for consistently reproducible right‑angle setups; order the component directly via Metav Werkzeuge or consult our technical advisors for application support.

M214.622 Angle Reference Column — 90° precision, 70 x 200 mm

The M214.622 angle reference column is a 90° reference component for workshop and inspection use, designed to provide a stable, high‑precision datum for angular measurement and alignment tasks.

• 90° ground reference face
• 0.005 mm high accuracy
• Hardened special steel construction
• Stable 7 kg mass for damping

Reduce inspection time with true metrology precision

The column serves as a compact angle reference that replaces improvised setups and reduces repositioning. With a certified 0.005 mm accuracy, the device establishes a clearly defined right‑angle datum that shortens setup times and lowers scrap rates. The geometry — 70 x 200 mm — is sized to give a sensible balance between reach and rigidity, making it suitable for bench inspection or integration into gauge fixtures. This level of precision supports consistent part acceptance criteria and streamlined quality control.

Built for repeatable use and industrial handling

Constructed from hardened special steel, the reference block resists wear and retains its surface integrity during repeated clamping and handling. Both the base and the mantle have been ground, producing flat, true faces that promote repeatable registration against workpieces or reference plates. The substantial 7 kg mass reduces the influence of incidental vibration, so measurement uncertainty is dominated by the instrument, not the environment. These attributes translate into fewer rechecks and a dependable reference for routine shop‑floor use.

Integrates cleanly into inspection workflows

The right‑angle reference is compact enough for bench use yet robust for workshop demands; it integrates with height gauges, dial gauges and coordinate equipment as a stable datum. The combination of ground faces and precise squareness supports comparative checks, alignment tasks and fixture verification. The component’s design reduces fixturing complexity: instead of fabricating bespoke stands, existing gauges can be referenced to the block, improving throughput and lowering fixturing cost. The unit is a practical investment for production lines and maintenance rigs seeking repeatable alignment.

Contact Metav Werkzeuge today to request a technical quote or specification sheet for the M214.622 angle reference column from Metav IndustryLine and to discuss suitability for specific inspection tasks

Technical data

• Article number: M214.622
• GTIN: 4054469183794
• Manufacturer: Metav IndustryLine

Facts

• Dimensions: 70 x 200 mm
• Accuracy: 0.005 mm
• Weight: 7 kg

Special features

• Hardened special steel, heat treated
• Stand face and mantle surface ground
• 90° reference geometry for angular alignment
• Category: Angle reference

FAQ

What applications is this reference column suited for?
The M214.622 angle reference column is intended for angular inspection, fixture alignment and comparative checks where a stable 90° datum is required.

How does the 0.005 mm accuracy affect daily use?
An accuracy of 0.005 mm means the reference column offers high confidence for tolerance checks and reduces rework caused by imprecise setup when using the Metav IndustryLine component.

Can the block be used on a shop floor?
Yes; the hardened special steel and ground faces make the column suitable for workshop environments where repeated handling and light fixture contact occur.

Is the M214.622 compatible with height gauges and dial indicators?
The column’s ground faces and standardised geometry allow straightforward referencing with height gauges, dial indicators and comparator fixtures.

What maintenance is required to keep accuracy?
Regular cleaning and careful handling of the ground faces will preserve the column’s performance; periodic verification against certified standards is recommended.

Manufacturer / Responsible: Metav Werkzeuge GmbH; Parkring 45; 46446 Emmerich; Germany; +49 2822 7131930; info@metav-werkzeuge.com