0.1–1 mm Gauge Pin Holder Green Aluminium Anodised, For 0.1–1 mm Pins - Metav IndustryLine

Benefit from the compact 46 mm anodised aluminium construction and the precisely defined 0.1–1 mm acceptance range to secure measuring pins reliably in tight fixtures; the green single-sided mount aids rapid identification on the shop floor. Order the holder directly via Metav Werkzeuge or consult their application specialists for integration support.

Measuring-pin holder GO 0.1–1 mm, anodised aluminium – Metav IndustryLine

A compact measuring-pin holder GO 0.1–1 mm designed to secure probe pins in precision gauges and inspection fixtures for repeatable alignment and clear GO/NOGO identification.

• Anodised aluminium body for corrosion resistance
• Accepts measuring pins 0.1–1 mm
• Single-sided green mount for clear identification
• Compact 46 mm length for tight assemblies

Secure positioning that supports repeatable measurements

The holder offers a secure, low-play interface for probe pins, engineered from anodised aluminium to combine rigidity with corrosion resistance. Designed for measuring pins in the 0.1–1 mm range, the unit maintains consistent seating under repeated insertions, reducing measurement scatter and setup variability. Where process repeatability matters, the compact construction helps preserve alignment between the pin and gauge, improving pass/fail reliability without adding unnecessary bulk.

Small form factor for easy integration into gauges and fixtures

With an overall length of 46 mm and a nominal width of 9 mm, this mount is optimised for confined assemblies and dense fixture layouts. The compact profile simplifies retrofitting into existing jigs or new inspection rigs, cutting assembly time and keeping clearances minimal. The single-sided configuration delivers a predictable orientation that streamlines installation and reduces the need for extra locating hardware, which supports faster line changeovers and leaner fixture design.

Durable finish and visual coding for efficient workflow

The green mount provides immediate visual identification for GO-side components in paired gauge systems, aiding operators during assembly and inspection. The anodised surface finish resists wear from repeated pin insertion and offers low maintenance over long service intervals. Lightweight yet robust, the holder contributes to lowered fixture mass and simpler handling while preserving the mechanical stability required for accurate inspection tasks, making it a practical choice for production and quality-control environments.

For reliable fixture performance, choose the Metav IndustryLine measuring-pin holder and contact Metav Werkzeuge in Emmerich for tailored advice or to arrange supply via info@metav-werkzeuge.com or +49 2822 7131930

Technical data

• Article number: M318.566.1
• Label: M318.566.1
• Manufacturer: Metav IndustryLine

Facts

• Length: 46 mm
• Width: 9 mm
• Measuring pin range: 0.1–1 mm

Special features

• Material: Aluminium, anodised
• Single-sided green mount for GO identification
• For the uptake of measuring pins
• Compact design for tight assemblies

FAQ

What pin sizes are compatible with the holder?
The measuring-pin holder GO 0.1–1 mm accepts probe pins from 0.1 mm up to 1 mm and is specifically specified for that range in the Metav IndustryLine product M318.566.1.

Is the mount suitable for repeated insertion cycles?
Yes, the anodised aluminium finish on the Metav IndustryLine measuring-pin holder resists wear from repeated insertions and is intended for regular use in inspection fixtures.

Can this holder be used in compact fixtures with limited clearance?
The compact 46 mm overall length and 9 mm width make the holder well suited to tight assemblies and compact gauge designs where space is at a premium.

Manufacturer / Responsible: Metav Werkzeuge GmbH; Parkring 45; 46446 Emmerich; Germany; +49 2822 7131930; info@metav-werkzeuge.com