5-6 mm Test Pin Holder, Green Aluminium Anodised, Single-Sided – Metav IndustryLine

Benefit from a compact, anodised aluminium construction combined with a secure clamp for 5–6 mm measuring pins and a one-sided, green mounting that speeds up fixture set-up. Order directly via Metav Werkzeuge or consult our advisors for application-specific guidance.

Measuring Pin Holder GO, 5–6 mm — anodised aluminium, one-sided green mounting (Metav IndustryLine)

The Measuring Pin Holder GO, 5–6 mm secures 5–6 mm probe pins for fixture and gauge assemblies, offering durable positioning and straightforward integration in workshop and inspection environments.

• Secure clamp for 5–6 mm pins
• Anodised aluminium construction
• Green one-sided mounting for fixtures

Consistent positioning for faster inspection cycles

A compact holder designed to deliver repeatable results: the clamping geometry keeps measuring pins aligned so that gauge checks and fixture measurements run with minimal variation. The design reduces setup times and lowers the risk of measurement error by ensuring that a 5–6 mm pin is held with stable contact and defined orientation. For quality control processes where cycle time and comparability matter, this component supports predictable inspection sequences and easier documentation of measurement procedures.

Robust, lightweight design that eases handling

Constructed from anodised aluminium, the holder combines corrosion resistance with low weight, which simplifies handling during assembly and reconfiguration of test rigs. The surface finish improves wear resistance and preserves the visual contrast of the green mounting for quick identification on crowded test benches. These material properties mean less maintenance, dependable appearance after repeated handling and a lower contribution to fixture mass, which is particularly useful when many holders are used across modular systems.

Simple integration into gauges and fixtures

The one-sided mounting facilitates fast placement in common gauge bodies and clamping blocks, providing a compact footprint without compromising stability. The holder accepts standard 5–6 mm measuring pins and is suitable for both probe pins and hardened gauging pegs used in inspection jigs. Compatibility with typical workshop tooling allows efficient retrofitting of existing fixtures and straightforward replacement when wear occurs, supporting continuous production and predictable inspection readiness.

For reliable repeatability and quick integration, contact Metav Werkzeuge for technical clarification or to request ordering details — Metav Werkzeuge provides expert advice from Emmerich and practical support for specifying the right holder for each gauge application.

Technical data

• Article number: M318.566.6
• Name: Measuring Pin Holder GO, 5–6 mm Green
• Manufacturer: Metav IndustryLine

Facts

• Width: 12 mm
• Length: 55 mm
• Colour: green

Special features

• For measuring pins 5–6 mm
• Anodised aluminium body
• One-sided green mounting
• For use in fixtures and gauges

FAQ

What pin diameters does this holder accept? The Measuring Pin Holder GO accepts measuring pins with a diameter of 5–6 mm and is intended for standard probe and gauge pegs.

What material and finish are used? The holder is made from anodised aluminium, providing a lightweight, corrosion-resistant surface suitable for repeated workshop use.

Can this be mounted in standard gauge blocks and fixtures? Yes, the one-sided green mounting allows easy placement in common fixture bodies and gauge assemblies for quick integration.

What is the article number for ordering? The SKU for ordering is M318.566.6; refer to this number when specifying the Measuring Pin Holder GO.

Manufacturer / Responsible: Metav Werkzeuge GmbH; Parkring 45; 46446 Emmerich; Germany; +49 2822 7131930; info@metav-werkzeuge.com