Ø20mm Anvil, Round-Head Accessory - Microtech Metrology

Take advantage of a dish-shaped anvil with a Ø20 mm measuring face for consistent reference points and repeatable results; its compact geometry supports stable contact and simple integration into inspection setups. Order the anvil directly via Metav Werkzeuge or consult our specialists for specification matching and delivery.

Anvil, dish-shaped – Ø20 mm measuring face by Microtech Metrology

An anvil designed as a dish-shaped measuring accessory for measuring instruments, providing a defined contact area for inspection and calibration tasks.

• Dish-shaped anvil, Ø20 mm measuring face
• Precision-machined measuring surface for repeatability
• Accessory for measuring instruments and test fixtures
• Compact geometry for stable reference contact

Consistent reference for repeatable measurements

The dish-shaped design creates a defined contact geometry that reduces variation when establishing a datum point on shafts, rings or small components. A single Ø20 mm measuring face provides a clear, repeatable reference area, which is especially useful when multiple operators or instruments are involved. By limiting contact to a stable, central surface, the accessory reduces ambiguous seating and helps maintain measurement consistency across inspection runs.

Integration into inspection workflows and fixtures

As an accessory for test benches and measuring instruments, the component is suitable for straightforward replacement in fixtures where a compact datum is required. Its form factor supports rapid set-up in repetitive control sequences and helps shorten cycle times in small-batch inspection. The result is improved throughput and lower rework rates because the defined measuring surface simplifies alignment and reduces operator interpretation during routine checks.

Robust handling and compatibility in the workshop

The compact, dish-shaped geometry keeps the part easy to handle and position on comparators, micromanipulators or custom jigs; its尺寸 minimises obstruction around the measurement point while maintaining a reliable seating area. The product from Microtech Metrology is conceived as a practical workshop accessory that prioritises clear reference contact and operational ease, supporting standardised measurement procedures without adding complexity to the toolset.

Contact Metav Werkzeuge for the Ø20 mm dish-shaped anvil from Microtech Metrology to confirm compatibility with existing fixtures and to secure a reliable measurement reference for production and quality control

Technical data

• Article number: 110750020
• GTIN: 4061905458408
• Manufacturer: Microtech Metrology

Facts

• Measuring face diameter: Ø20 mm
• Shape: dish-shaped anvil
• Category: Accessory for measuring instruments

Special features

• Precision-machined measuring surface
• Compact geometry for stable contact
• Suitable for use as a datum in inspection setups

FAQ

What is the primary use of this dish-shaped anvil?
The dish-shaped anvil is intended as an accessory datum for measuring instruments and fixtures; the Ø20 mm measuring face provides a repeatable contact area for inspection and alignment when using the Microtech Metrology anvil (SKU 110750020).

Which instruments is the anvil compatible with?
The anvil is compatible with comparators, test fixtures and measuring benches that accept accessory anvils; the Microtech Metrology dish-shaped design is intended for use where a compact, defined reference surface is required.

Is the measuring face suitable for small-diameter components?
Yes. The Ø20 mm measuring face concentrates contact in a central area, making it appropriate as a reference on shafts, rings and other small components where a defined seating is needed.

Manufacturer / Responsible: Microtech, Nizhneyurkovska str., 45a, 04080 Kyiv, Ukraine, tool@microtech.tools