0.7 mm Flat Micrometer Anvil Pair, Supplied in Pairs - Metav IndustryLine

Take advantage of the matched anvil pair to restore or extend the measuring range of compatible micrometers while maintaining consistent contact geometry; the flat 0.7 mm diameter faces provide a defined reference for repeatable thickness or step measurements. Order the replacement set directly via Metav Werkzeuge or contact the consultancy team for fitting advice.

Pair of flat anvils for uni micrometer, 0.7 mm diameter — Metav IndustryLine

The Pair of flat anvils for uni micrometer, 0.7 mm diameter is a precision replacement anvil set designed to re-establish accurate contact geometry for fine measurement tasks on uni micrometers and related instruments.

• Flat 0.7 mm diameter anvil
• Supplied as a matched pair
• Compatible with uni micrometer models
• Precision contact for repeatable readings

Precision where small detail matters

The flat 0.7 mm contact faces deliver a clearly defined measurement interface that reduces ambiguity when measuring thin sections, small steps or delicate parts. A narrow, flat anvil is particularly valuable where standard spherical or larger faces would introduce measurement uncertainty or fail to access confined geometries. By using purpose‑designed flat contacts the instrument records a consistent reference plane, which improves repeatability and simplifies comparison across serial parts. This specification supports tasks in quality control and fine mechanical assembly where stable contact geometry is essential.

Matched pair for consistent measurement results

Supplied as a matched pair, the two anvils are intended to be used together to preserve symmetry and balance in the micrometer's measuring circuit. Matched components minimise systematic offsets that can occur when replacing only a single contact face, so measured values remain comparable over time and between instruments. For workshop calibration routines and routine inspection, this approach reduces the need for frequent realignment and supports process stability, helping to maintain traceable measurement chains when used alongside documented procedures.

Simple integration and robust handling

These anvils are made as a compact accessory that integrates directly with standard uni micrometer fittings, allowing quick replacement without modification to the instrument. Their light mass (0.1 kg for the pair) and compact form mean minimal effect on the instrument’s handling and zero point. The accessory is suited to environments where space and manoeuvrability matter, such as bench inspection stations and precision assembly lines. When combined with a disciplined measurement procedure and appropriate fixturing, the flat anvils contribute to faster inspection cycles and fewer adjustments.

For tailored advice on compatibility with specific uni micrometer models or for procurement assistance, contact Metav Werkzeuge — Metav IndustryLine replacements are available from the Emmerich distribution hub and technical consultants can advise on fit and application.

Technical data

• Article number: M309.088.2
• GTIN: 4054469117959
• Description: Flat 0.7 mm
• Delivery: Supplied as a pair
• Weight: 0.1 kg

Facts

• Diameter: 0.7 mm
• Weight (pair): 0.1 kg
• Tariff number: 90173000
• ECLASS: 21170324

Special features

• Accessory for uni micrometer
• Matched anvil pair for symmetric contact
• Compact design for confined measurements
• Category: Accessories (measuring devices)

FAQ

What is the contact diameter of the anvils? The contact diameter is 0.7 mm and the set comprises flat faces intended for precise, well‑defined contact points.

Are these supplied as a single anvil or a matched pair? The item is supplied as a matched pair to preserve symmetric contact geometry and to reduce systematic measurement deviation.

Which micrometer models are these anvils compatible with? These anvils are made for use with uni micrometer fittings; compatibility checks are recommended with the specific instrument model before fitting.

How should the anvils be used to ensure repeatable measurements? Use the matched pair in the micrometer as intended, ensure stable fixturing of the workpiece and follow established measuring routines to maintain repeatability.

Manufacturer / Responsible: Metav Werkzeuge GmbH; Parkring 45; 46446 Emmerich; Germany; +49 2822 7131930; info@metav-werkzeuge.com