50 mm End Gauge Holder Very Sturdy Design, 0–50 mm Range - Metav IndustryLine

The combination of very stable construction and a precise 0–50 mm clamping range ensures reproducible results for gauge and end-measure work; the compact cross-section and low mass keep handling straightforward while maintaining accuracy. Order the gauge block holder directly via Metav Werkzeuge or consult our specialists for application advice.

Gauge block holder 50 mm — 0–50 mm clamping range, Metav IndustryLine

A gauge block holder 50 mm designed to secure end measures during calibration and precision measurement tasks in metrology laboratories and workshop environments.

• Very stable construction for reproducible clamping
• Clamping range 0–50 mm for standard gauge work
• Compact cross-section 30.5 x 2.5 mm for precise fit
• Lightweight 0.4 kg for easy handling in the lab

Consistent clamping for repeatable measurements

The robust design delivers reproducible positioning of end measures, making it a reliable fixture for routine calibration and inspection procedures. With a defined 0–50 mm clamping range, the unit supports standard gauge blocks and end measures used across inspection benches and calibration rigs. The compact profile minimises play at the contact points, which helps to reduce measurement uncertainty and supports consistent results during serial checks or single‑part verifications.

Smooth integration into workshop and laboratory workflows

Engineered for straightforward handling, the holder’s modest mass and narrow cross-section ease alignment and placement in tight setups. Its lightweight nature (approx. 0.4 kg) reduces operator fatigue during repeated use and speeds up cycle times in quality control processes. As a consequence, throughput improves without compromising the precision required for certification or acceptance testing, delivering efficiency gains that support both small workshops and larger metrology departments.

Durable build that supports long-term inspection routines

Constructed for enduring service, the fixture withstands regular handling while maintaining the geometric stability necessary for traceable measurement work. The very stable construction reduces the need for frequent realignment and contributes to a lower total cost of ownership through fewer process interruptions. Compatibility with standard end measures ensures straightforward integration into existing gauge sets, simplifying inventory and tooling decisions for procurement and workshop managers.

For dependable gauge work choose the Metav IndustryLine holder and contact Metav Werkzeuge in Emmerich for tailored advice or to arrange supply

Technical data

• Article number: M317.103
• SKU: M317.103
• GTIN: 4054469127330
• Category: Endmasse (gauge blocks)
• eClass: 21170108

Facts

• Clamping range: 0–50 mm
• Cross-section: 30.5 x 2.5 mm
• Weight: 0.4 kg
• Tariff number: 90173000

Special features

• Very stable construction
• Suitable for use with end measures and gauge blocks
• Compact design for tight setups
• Story trigger: endmasse

FAQ

What clamping range does the holder cover?
The gauge block holder 50 mm (Metav IndustryLine, SKU M317.103) covers a clamping range of 0–50 mm, suitable for standard end-measure tasks.

Is this holder suitable for calibration workflows?
Yes. The holder’s stable design and precise clamping make it well suited for calibration and repeatable inspection routines using gauge blocks and end measures.

How heavy is the unit and how does that affect handling?
Weighing approximately 0.4 kg, the holder is lightweight enough for easy alignment and frequent handling while remaining rigid enough for stable measurements.

Which profile dimensions aid precise fitting in setups?
The compact 30.5 x 2.5 mm cross-section allows secure placement in narrow fixtures and helps to maintain consistent contact geometry during measurements.

Manufacturer / Responsible: Metav Werkzeuge GmbH; Parkring 45; 46446 Emmerich; Germany; +49 2822 7131930; info@metav-werkzeuge.com