100mm End Gauge Holder Very Sturdy Design - Metav IndustryLine

Take advantage of the combination of robust construction, a precise 0–100 mm clamping range and compact handling to secure reproducible measurement results. Order this end gauge holder directly via Metav Werkzeuge or ask our consultants for application advice.

End gauge holder 0–100 mm — Robust clamping, Metav IndustryLine

The End gauge holder 0–100 mm secures gauge blocks for precise measurement and calibration in workshop and laboratory metrology.

• Very robust construction
• Clamping range 0–100 mm
• Compact, lightweight at 0.4 kg
• Suitable for precise calibration tasks

Repeatable clamping for reliable measurement results

A stable clamping device is the basis for reproducible results in any inspection routine. The holder is designed for robust fixation of end gauges and gauge blocks, reducing slippage and ensuring consistent contact geometry across repeated measurements. With a clear 0–100 mm range and a compact build, the unit minimises setup time and mechanical variables that typically cause measurement drift. The result is an efficient inspection workflow that maintains traceability and supports quality control procedures.

Ideal for compact metrology and calibration benches

This holder is engineered for benches where space and access are limited but accuracy remains essential. The compact design and low mass of 0.4 kg make handling straightforward while preserving stiffness where it matters: at the clamping interface. That combination benefits tasks such as small-part gauging, calibration of comparators, and fixture alignment, where ease of positioning and steady support translate directly into time savings and fewer re-measurements.

Built for workshop durability and precise adjustment

Constructed to withstand routine use, the holder features a very stable design that copes with workshop environments without sacrificing precision. The robust build reduces the need for frequent readjustment and helps protect gauge block surfaces during handling. As a Metav IndustryLine product, the component is intended to integrate into existing metrology equipment and inspection processes, offering a practical compromise between laboratory precision and shop-floor resilience.

For robust 0–100 mm gauge holding and dependable measurement reproducibility, contact Metav Werkzeuge for product advice or to arrange procurement through Metav Werkzeuge.

Technical data

• Article number: M317.204
• GTIN: 4054469127507
• eClass: 21170108
• Customs tariff: 90173000

Facts

• Measurement range: 0–100 mm
• Weight: 0.4 kg
• Cross-section: bis 300mm 30x5mm und ab 300mm 30x6,7mm

Special features

• Very robust construction
• Designed for end gauges / gauge blocks
• Compact format for bench use
• Category: End gauges

FAQ

What is the clamping range of the holder?
The clamping range is 0–100 mm, suitable for common end gauges and gauge blocks used in small-part inspection.

Is the holder suitable for calibration tasks on a workshop bench?
Yes, the holder is designed for precise calibration work and stable repeatability in workshop and bench environments.

Which Metav SKU identifies this product?
This product is listed as M317.204 under the Metav IndustryLine range.

How heavy is the device and does it require special mounting?
The unit weighs 0.4 kg and is compactly designed for manual placement on calibration benches; no special mounting is required for standard use.

Manufacturer / Responsible: Metav Werkzeuge GmbH; Parkring 45; 46446 Emmerich; Germany; +49 2822 7131930; info@metav-werkzeuge.com