1.008 mm End Gauge Grade 0 DIN EN ISO 3650, Hardened Special Steel - Metav IndustryLine

Take advantage of the combination of a Grade 0 tolerance, the DIN EN ISO 3650 standard and a compact 1.008 mm nominal length to establish a reliable reference in calibration work; order the gauge block directly via Metav Werkzeuge or consult the Metav specialists for precise application advice

Single gauge block 1.008 mm, Grade 0 (DIN EN ISO 3650) — hardened special-steel reference by Metav IndustryLine

The Single gauge block 1.008 mm, Grade 0 (DIN EN ISO 3650) is a high-precision reference element intended for calibration, master-setting and dimensional verification in laboratories and workshop quality control

• Grade 0 tolerance (DIN EN ISO 3650)
• Hardened special steel construction
• Reference length 1.008 mm
• Compact cross-section 30 x 9 mm

Accuracy that secures measurement chains

This reference piece offers Grade 0 accuracy under the DIN EN ISO 3650 standard, providing a traceable and stable reference for comparators, micrometres and calibration benches. The nominal length of 1.008 mm is manufactured to narrow tolerance bands, which reduces uncertainty when transferring dimension standards across instruments. As a consequence, repeat measurements become more consistent and process-related rework is minimised, supporting efficient quality control workflows.

Material design for long-term stability

Made from hardened special steel, the block combines wear resistance with dimensional stability under normal workshop and laboratory conditions. The compact 30 x 9 mm cross-section (applicable for nominal lengths up to 10 mm) gives a rigid geometry that resists distortion during handling, while the low mass facilitates safe placement in gauge sets and holders. This construction ensures the reference remains usable over many calibration cycles, lowering total cost of ownership through extended service life.

Practical application and integration into inspection routines

As a fundamental reference element, the gauge block integrates seamlessly into calibration routines and setting procedures. It is suited to establish master lengths, verify micrometre zero settings and serve as a comparison standard on inspection benches. The simple geometry of this gauge block aids rapid alignment and reliable contact with measuring tips, helping to speed up routine checks and minimise operator influence on results. Conformity to the recognised standard simplifies documentation and supports procurement decisions in regulated environments.

Contact Metav Werkzeuge for tailored advice on integrating this Grade 0 reference into calibration sets or to request technical details from the Metav specialists at info@metav-werkzeuge.com or by phone +49 2822 7131930

Technical data

• Article number: M319.01008.0
• GTIN: 4054469130125
• Customs tariff no.: 90173000

Facts

• Nominal length: 1.008 mm
• Tolerance grade: 0
• Weight: 0.004 kg
• Cross-section (≤10 mm): 30 x 9 mm

Special features

• Material: hardened special steel
• Standard: DIN EN ISO 3650
• Category: Gauge block / End gauge
• Brand: Metav IndustryLine

FAQ

What level of accuracy does this block provide?
The single gauge block meets Grade 0 accuracy according to DIN EN ISO 3650, offering tight tolerances suitable for reference and calibration tasks.

Is this block suitable for use as a master standard in a workshop?
Yes, the Single gauge block 1.008 mm, Grade 0 (DIN EN ISO 3650) is designed for master-setting and routine verification in both workshop and laboratory environments.

What material is the gauge block made from and why does it matter?
The block is forged from hardened special steel, chosen for dimensional stability and wear resistance to ensure long-term reliability during repeated calibration cycles.

Manufacturer / Responsible: Metav Werkzeuge GmbH; Parkring 45; 46446 Emmerich; Germany; +49 2822 7131930; info@metav-werkzeuge.com