1.3 mm Gauge Block, DIN EN ISO 3650 Grade 0, Hardened Special Steel - Metav IndustryLine

Take advantage of the combination of Grade 0 accuracy, hardened special steel construction and a compact cross-section for reliable reference measurements; order the single gauge block directly via Metav Werkzeuge or ask our consultants if needed.

Single gauge block 1.3 mm — Gauge block, Grade 0, DIN EN ISO 3650 (Metav IndustryLine)

The single gauge block 1.3 mm delivers a traceable reference length for precision inspection and calibration in shop-floor and laboratory metrology.

• Grade 0 accuracy to DIN EN ISO 3650
• Hardened special steel construction
• Compact cross-section 30 x 9 mm

Repeatable reference for precision workflows

The Grade 0 tolerance classification according to DIN EN ISO 3650 positions this gauge block as a high‑accuracy reference for dimensional control. With a nominal length of 1.3 mm the block is intended for use in length standards, gauge block stacks and comparative checks where reproducibility matters. The compact geometry and low mass support fast handling in routine checks while preserving flatness and contact integrity required for repeatable measurements.

Robust material and stable geometry for longevity

Manufactured from hardened special steel, this end gauge offers enhanced wear resistance and dimensional stability compared with untreated variants. The standard cross-section of 30 x 9 mm (applicable for nominal lengths up to 10 mm) reduces bending under manual handling and provides a dependable contact area for measurement instruments. These attributes minimise drift over time and maintain serviceability under regular calibration cycles.

Practical role in measurement chains and quality assurance

As a reference standard, the block integrates into comparator setups, micrometre checks and verification of callipers, helping to shorten set‑up times and improve inspection throughput. The small footprint of the block makes it suited to stacked assemblies and gauge sets, allowing precise incremental steps when assembling a calibration stack. The combination of recognised standard conformity and stable construction supports consistent results across production runs and inspection points.

Contact Metav Werkzeuge for specification advice and reliable supply of Metav IndustryLine gauge blocks; Metav Werkzeuge GmbH in Emmerich provides practical sourcing and technical guidance.

Technical data

• Article number: M319.013.0
• GTIN: 4054469130743
• Label: Einzel-Endmaß 1,3 mm, DIN ISO 3650, Güte 0 DIN ISO 3650

Facts

• Nominal length: 1.3 mm
• Weight: 0.005 kg
• Cross-section: 30 x 9 mm

Special features

• Hardened special steel
• Conforms to DIN EN ISO 3650
• Grade 0 tolerance
• Category: Gauge blocks / End gauges
• Tariff number: 90173000

FAQ

What tolerance class does this gauge block have?
The single gauge block 1.3 mm from Metav IndustryLine is specified as Grade 0 in accordance with DIN EN ISO 3650, indicating a high level of dimensional accuracy for reference use.

Which material is the block made from?
The gauge block is made from hardened special steel, chosen for its wear resistance and dimensional stability under repeated contact.

For which measuring tasks is this block intended?
This end gauge is suitable for establishing reference lengths in stacks, checking micrometres and verifying calipers where compact, accurate steps of 1.3 mm are required.

What cross-section applies to this nominal length?
For nominal lengths up to 10 mm the applicable cross-section is 30 x 9 mm, which provides a stable contact area and good handling characteristics.

Can this block be included in a gauge block set?
Yes; the 1.3 mm block is designed for use within gauge block stacks and as an individual reference element in calibration and inspection chains.

Manufacturer / Responsible: Metav Werkzeuge GmbH; Parkring 45; 46446 Emmerich; Germany; +49 2822 7131930; info@metav-werkzeuge.com