100 mm Gauge Block, Grade 0, Hardened Special Steel, DIN EN ISO 3650 - Metav IndustryLine

Take advantage of Grade 0 accuracy, hardened special steel construction and strict DIN EN ISO 3650 conformity for reliable reference measurements and repeatable set-ups — order directly via Metav Werkzeuge or consult our specialists for selection advice.

Single gauge block 100 mm — Grade 0, DIN EN ISO 3650 (Metav IndustryLine)

The Single gauge block 100 mm is a precision reference length for calibration, inspection and machine set-up tasks in production and metrology environments.

• Grade 0 accuracy to DIN EN ISO 3650
• Hardened special steel construction
• Nominal length 100 mm
• Precision reference for calibration labs

Confidence from standardised accuracy

Manufactured to DIN EN ISO 3650 and classified as Grade 0, this reference element provides a documented tolerance class for high‑precision comparison and length setting. The tight tolerance of the Grade 0 specification reduces setup time and measurement uncertainty when establishing reference chains or verifying instruments. As a traceable length standard, the block supports reproducible measurement procedures and helps to maintain process stability across inspection routines.

Robust design for repeatable handling

The block is produced from special steel, hardened to ensure long service life and consistent surface integrity under regular use. The compact geometry and defined cross-section sizes maintain stiffness and simplify positioning between holders or on reference plates. At approximately 0.243 kg, the piece is easy to manipulate while remaining substantial enough for stable contact during comparisons. These characteristics lower the risk of handling‑induced deviation and make the element suitable for both workshop and laboratory environments.

Practical role in measurement and production workflows

Used as a reference for calibrating micrometers, setting gauge lengths and checking machine offsets, this precision length standard reduces downtime associated with frequent verification. The block supports efficient quality assurance workflows by providing a reliable master length that integrates into master sets and inspection benches. Metav IndustryLine’s supply reliability and broad product range further simplify reordering and set completion for busy workshops and calibration laboratories.

Contact Metav Werkzeuge in Emmerich for tailored advice on integrating this Grade 0 100 mm reference into inspection routines or for assistance with kit selection and rapid supply

Technical data

• SKU: M320.100.0
• GTIN: 4054469132341
• Norm: DIN EN ISO 3650

Facts

• Nominal length: 100 mm
• Tolerance grade: 0
• Weight: 0.243 kg
• Tariff number: 90173000

Special features

• Material: Special steel, hardened
• Cross-section (≤10 mm): 30 x 9 mm
• Cross-section (>10.1 mm): 35 x 9 mm
• Category: Gauge blocks / End measures

FAQ

What tolerance class does this gauge block meet?
The Single gauge block 100 mm meets Grade 0 tolerances according to DIN EN ISO 3650, providing the dimensional stability required for high‑precision comparisons.

Which material is used and how does it affect wear?
This Metav IndustryLine gauge block is produced from special steel, hardened, which gives good wear resistance and maintains surface integrity during repeated use.

Is the block suitable for workshop and laboratory use?
Yes — the 100 mm nominal length and robust construction make this gauge block appropriate for calibration benches, comparator setups and workshop verification tasks.

How should the block be stored to preserve accuracy?
Store the block clean and dry, ideally in a protective case or drawer to avoid corrosion and surface damage; the hardened steel construction helps, but careful storage preserves long‑term accuracy.

What is the SKU for ordering and traceability?
The product is listed under SKU M320.100.0 (Metav IndustryLine) and GTIN 4054469132341 for ordering and inventory control.

Manufacturer / Responsible: Metav Werkzeuge GmbH; Parkring 45; 46446 Emmerich; Germany; +49 2822 7131930; info@metav-werkzeuge.com