2.17mm Gauge Pin Single ±0.001 mm Length 50 mm Workshop Version - Metav IndustryLine

Take advantage of the combination of micron-level accuracy, robust workshop construction and compact length for reproducible end‑measure checks; order the gauge pin directly via Metav Werkzeuge or contact our consultants for application advice.

M323.217 gauge pin — 2.17 mm diameter, ±0.001 mm accuracy by Metav IndustryLine

A precision M323.217 gauge pin designed for fine end‑measure verification and dimensional checks in workshop environments.

• Precision diameter 2.17 mm ±0.001 mm
• Length 50 mm for deep or recessed checks
• Workshop‑grade special steel construction
• Supplied in protective transport case

Micron-level accuracy for critical dimensional checks

The core benefit of this measuring pin is its ±0.001 mm tolerance, equivalent to 1 µm, which supports high‑precision verification tasks where repeatability matters. Such accuracy is suitable for end‑measure inspections, plug‑gauge comparisons or tactile checks on small bores and mating parts. The tight tolerance reduces uncertainty in pass/fail decisions and shortens inspection cycles, delivering measurable gains in quality assurance procedures.

Compact form and durable workshop design for everyday use

With a nominal diameter of 2.17 mm and a length of 50 mm, the pin reaches into recessed features while remaining easy to handle. The special steel construction provides wear resistance in repetitive measurement routines and keeps the contact geometry stable over many cycles. Supplied in a protective transport case, the tool remains protected during storage and transit, preserving the calibrated condition and minimising downtime due to damage.

Integrates into inspection routines and fixture setups

This single gauge pin is ideal for quick reference checks, fixture setting and comparative measurement tasks in metalworking and precision assembly. Its compact mass supports fast manual handling and repeat measurements with minimal operator fatigue. Traceability is supported through the clear product identification and packaging, enabling straightforward inventory control and replacement planning in serial inspection workflows.

For precise end‑measure control choose the Metav IndustryLine M323.217 gauge pin and contact Metav Werkzeuge for personalised technical guidance at info@metav-werkzeuge.com or by phone on +49 2822 7131930

Technical data

• Article number: M323.217
• GTIN: 4061905055706
• Label: Prüfstift, einzeln, 2,17mm, +/- 0.001 mm Länge 50 mm

Facts

• Diameter: 2.17 mm
• Tolerance: ±0.001 mm
• Length: 50 mm
• Weight: 0.004 kg

Special features

• Material: Special steel
• Workshop version
• Supplied in protective transport case
• Category: Messstifte

FAQ

What level of accuracy does the pin provide?
The M323.217 gauge pin offers an accuracy of ±0.001 mm, corresponding to 1 µm, suitable for high‑precision dimensional checks.

Which materials is the pin suitable for inspecting?
The pin is a measuring artefact for dimensional control and is used to check bores and mating parts produced from a wide range of workshop materials.

How is the gauge pin delivered?
The M323.217 is supplied in a protective transport case to prevent damage during storage and transport.

Can the pin be used for embedded or recessed measurements?
Yes, the 50 mm length allows checking of recessed features and bores that require slightly deeper reach.

Is this item intended for continuous workshop use?
The workshop‑grade construction and special steel material make this pin well suited to routine inspection tasks in production environments.

Manufacturer / Responsible: Metav Werkzeuge GmbH; Parkring 45; 46446 Emmerich; Germany; +49 2822 7131930; info@metav-werkzeuge.com