2.2mm Gauge Pin Single, ±0.001mm Accuracy, 50mm Length, Workshop Version - Metav IndustryLine

This precision gauge combines ±0.001 mm tolerance, a slender 2.20 mm diameter and a compact 50 mm length to deliver reproducible end‑measurements in routine inspection tasks. Order the gauge pin directly via Metav Werkzeuge or consult our specialists for selection advice.

Metav IndustryLine Gauge pin M323.220 — 2.20 mm, ±0.001 mm, 50 mm

Gauge pin M323.220 for fine bore and end‑measurement checks in workshop inspection and setup operations

• Workshop‑grade precision pin ±0.001 mm
• Diameter 2.20 mm for fine bore checks
• 50 mm hardened special steel shaft
• Supplied in protective transport case

Precision where tolerances drive decisions

High‑accuracy inspection benefits from the very low tolerance of ±0.001 mm, which reduces measurement uncertainty during pass/fail checks and first‑off inspections. The narrow 2.20 mm diameter is intended for fine bores and alignment pins where small clearances must be verified; given its compact 50 mm length the component is easy to position in fixtures and measuring benches. This level of repeatability supports faster decision making on the shop floor and helps to avoid downstream rework.

Built for everyday workshop use

The workshop version construction uses special steel for a durable measuring surface that resists wear under frequent handling. The single‑piece design keeps form error minimal and simplifies storage between uses. Supplied individually and housed in a protective transport case, the gauge remains protected from knocks and contamination while not in use. These design choices translate into lower tool turnover and steadier inspection throughput in a production environment.

Faster inspection loops and straightforward integration

Traceability is supported by the clear article identification (SKU M323.220) and GTIN for inventory control and ERP integration. The gauge pin is suitable for manual plug checks, fixture inserts and quick layout control operations, enabling inspectors to confirm bores and end dimensions without complex set‑ups. The compact format reduces handling time and, when combined with consistent manufacture, makes statistical process control simpler and more reliable on repetitive runs.

Choose the Metav IndustryLine gauge pin M323.220 for dependable fine‑bore verification — contact Metav Werkzeuge in Emmerich for tailored advice at info@metav-werkzeuge.com or by phone on +49 2822 7131930

Technical data

• Article number: M323.220
• GTIN: 4061905056451
• Brand: Metav IndustryLine

Facts

• Diameter: 2.20 mm
• Length: 50 mm
• Tolerance: ±0.001 mm
• Weight: 0.004 kg

Special features

• Material: Special steel
• Workshop version
• Supplied individually
• Protective transport case

FAQ

What applications is this gauge pin intended for?
The gauge pin M323.220 from Metav IndustryLine is designed for fine bore checks, end‑measurement verification and quick fixture validation in workshop inspection.

Is a calibration certificate delivered with the pin?
No specific calibration note is provided for this item; the M323.220 is supplied as an individually packaged workshop gauge without an explicit calibration certificate unless otherwise ordered.

Which material is used for the shaft?
The shaft is made of special steel, chosen for wear resistance and consistent surface quality during routine measurement tasks.

Can the pin be used in hand‑held plug gauges and fixtures?
Yes, the compact 50 mm length and slender 2.20 mm diameter make the pin suitable for plug gauges, fixture inserts and manual check procedures.

How is the product identified for inventory and ordering?
Use the SKU M323.220 and GTIN 4061905056451 for ordering and stock management of this Metav IndustryLine gauge pin.

Manufacturer / Responsible: Metav Werkzeuge GmbH; Parkring 45; 46446 Emmerich; Germany; +49 2822 7131930; info@metav-werkzeuge.com