5.8mm Gauge Pin ±0.001mm Length 50mm Workshop Finish - Metav IndustryLine

Precision of ±0.001 mm, a compact 50 mm length and special steel construction ensure repeatable end-measurements in workshop environments; order the pin directly via Metav Werkzeuge or consult our specialists for application advice.

M323.580 gauge pin — 5.80 mm diameter, ±0.001 mm tolerance (Metav IndustryLine)

The M323.580 is a workshop-grade cylindrical gauge pin intended for accurate bore verification, fixture setting and end-measurement tasks in production environments.

• Workshop-grade special steel
• Diameter 5.80 mm, tolerance ±0.001 mm
• Length 50 mm for end-measurements
• Supplied in transport case

Accurate, repeatable checks for routine metrology

Aiming for measurable reproducibility, this cylindrical gauge pin delivers a declared tolerance of ±0.001 mm (±1 µm) on a nominal diameter of 5.80 mm, enabling fine verification of bore diameters and alignment features. The tight tolerance reduces uncertainty in pass/fail decisions and supports traceable in-process checks. In practice, the compact 50 mm shaft length provides a stable contact area for end-measurements while keeping handling straightforward and cycle times short. The precise dimensional data gives a sound basis for statistical process control and minimises downstream rework.

Robust design and material for workshop conditions

Designed as a workshop-grade tool, the pin is manufactured from special steel selected for wear resistance and dimensional stability under repeated use. The relatively low mass (approximately 0.013 kg) and solid construction reduce susceptibility to bending during insertion and retraction, preserving measurement integrity. Supplied in a protective transport case, the pin remains protected from contamination and mechanical damage during storage and transit, which helps maintain the declared surface condition and tolerance over many inspection cycles. These practical design choices translate directly into lower lifetime cost through reduced replacement frequency.

Integration into quality workflows and fixture setup

The cylindrical geometry and precise diameter make this pin suitable as a reference for setting up jigs, calibrating holders and checking bores in series production. As a single, traceable reference artefact, it simplifies go/no-go assessments when paired with standardised test procedures. The compact form factor supports easy interchange between manual inspection benches and automated stations where a simple cylindrical gauge is required. Supplied identification such as GTIN 4061905059469 and the article designation enable clear inventory control and integration into calibration schedules.

Secure reliable ±0.001 mm workshop measurement by contacting Metav Werkzeuge for procurement and technical guidance on suitable inspection workflows and accessories

Technical data

• Article number: M323.580
• GTIN: 4061905059469
• Label: Prüfstift, einzeln, 5,80mm, +/- 0.001 mm Länge 50 mm

Facts

• Diameter: 5.80 mm
• Tolerance: ±0.001 mm
• Length: 50 mm
• Weight: 0.013 kg

Special features

• Material: Special steel
• Workshop execution
• Supplied in transport case
• Category: Messstifte

FAQ

What is the declared tolerance of this gauge pin?
The M323.580 gauge pin is specified with a tolerance of ±0.001 mm, suitable for high-precision workshop checks.

Which material is the pin made from?
The pin is manufactured from special steel designed for wear resistance and dimensional stability in workshop use.

Is the gauge pin supplied with protection for transport?
Yes, the M323.580 is supplied in a protective transport case to guard against contamination and damage.

For which tasks is this gauge pin intended?
The pin is intended for bore verification, fixture setting and end-measurement tasks in production and inspection environments.

How does the M323.580 support quality processes?
With its declared accuracy and traceable identification, the M323.580 serves as a reproducible reference for in-process checks and setup routines

Manufacturer / Responsible: Metav Werkzeuge GmbH; Parkring 45; 46446 Emmerich; Germany; +49 2822 7131930; info@metav-werkzeuge.com