8.15mm Gauge Pin, Single, ±0.001mm Accuracy, 50mm Length, Workshop Version - Metav IndustryLine

Take advantage of the pin's ultra‑fine tolerance and robust workshop design to secure reproducible end‑measurements with minimal setup time; the gauge pin's ±0.001 mm accuracy and 50 mm length ensure reliable fit testing across production runs. Order the single inspection pin directly via Metav Werkzeuge or consult the Metav team for specification matching.

M323.815 Gauge pin — 8.15 mm, ±0.001 mm (Metav IndustryLine)

The M323.815 is a single gauge pin for precision end‑measurements and go/no‑go checks in workshop and inspection environments.

• Workshop version for robust daily use
• Diameter 8.15 mm with ±0.001 mm accuracy
• Length 50 mm for precise end measurements

High‑precision control that reduces rework

Designed for inspection tasks where dimensional certainty matters, this gauge pin offers ±0.001 mm (1 µm) tolerance to support tight acceptance criteria. Such fineness of control reduces the need for repeated adjustments and downstream rework, improving throughput in small‑batch and serial production alike. The pin acts as a reliable reference for plug and bore checks, helping to validate assembly fits and final tolerances without complex fixtures.

Built for everyday handling in industrial workshops

The workshop configuration combines a hardened special steel construction with a compact 50 mm length to balance stiffness and manoeuvrability. The robust finish resists typical wear encountered during daily use, while the single‑piece design simplifies storage and selection in inspection trays. Delivery includes a protective case for safe transport and handling, preserving the measuring surface between uses.

Practical benefits: quick checks, consistent results

With an exact diameter of 8.15 mm, the pin supports repeatable go/no‑go assessments and end‑mass verifications across batches. The simple geometry minimises handling variance, so measurement routines can be standardised on the shop floor and integrated into quality control procedures. Traceable dimension conformity shortens inspection cycles and provides a dependable reference for assembly checks.

Contact Metav Werkzeuge for tailored advice on integrating the Metav IndustryLine M323.815 gauge pin into inspection routines; call +49 2822 7131930 or email info@metav-werkzeuge.com to confirm suitability and availability

Technical data

• Article number: M323.815
• GTIN: 4061905060557
• Label: Prüfstift, einzeln, 8,15mm, +/- 0.001 mm Länge 50 mm

Facts

• Diameter: 8.15 mm
• Length: 50 mm
• Tolerance: ±0.001 mm (1 µm)
• Weight: 0.025 kg

Special features

• Material: Special steel
• Workshop execution for everyday use
• Delivered in protective case for transport
• Single inspection pin for end measurements
• Category: Gauge pins (Messstifte)

FAQ

What inspections is this gauge pin suited for?
The M323.815 gauge pin is intended for end‑measurements, plug and bore checks and go/no‑go verifications where a precise 8.15 mm reference is required.

Is the tolerance of ±0.001 mm sufficient for bore acceptance testing?
Yes, the ±0.001 mm tolerance of this inspection pin provides sub‑micrometre precision suitable for tight acceptance criteria and fine fit validation.

What is the material and how does it affect wear resistance?
The pin is made from special steel, chosen for durability and resistance to wear encountered during frequent insertion and removal.

Manufacturer / Responsible: Metav Werkzeuge GmbH; Parkring 45; 46446 Emmerich; Germany; +49 2822 7131930; info@metav-werkzeuge.com