8.95mm Gauge Pin, Single, ±0.001 mm Accuracy, 50mm Length, Workshop Version - Metav IndustryLine

High‑precision 8.95 mm gauge pin with ±0.001 mm tolerance and a 50 mm usable length provides consistent end‑measurements and reliable repeatability in workshop inspection routines; robust special steel and workshop finish ensure long service life. Order the gauge directly via Metav Werkzeuge or consult our specialists for application advice.

Pin gauge M323.895 — 8.95 mm, ±0.001 mm (50 mm length) — Metav IndustryLine

A pin gauge M323.895 designed for precision end‑measurements and inspection tasks in small‑component and workshop metrology environments

• ±0.001 mm tolerance for exact end measurements
• Diameter 8.95 mm in precision ground finish
• 50 mm usable length for deep features
• Supplied in a protective transport case

Accuracy that cuts rework and saves inspection time

High resolution and minimal deviation are decisive in batch inspection. The ±0.001 mm tolerance of this gauge pin translates into repeatable checks of bores, shafts and end‑dimensions with micrometric certainty, reducing the risk of scrap and rework. In practical terms, a tight tolerance means fewer secondary checks and faster decision making on the shop floor; inspections become a reliable pass/fail gate rather than a time‑consuming doubt. The measurable benefit is predictable quality output and streamlined production control.

Built for workshop use — durable, stable and easy to handle

Constructed from special steel and finished for workshop conditions, the pin offers mechanical resilience and resistance to everyday wear. The 50 mm nominal length provides access into deeper features while maintaining stiffness for stable contact; the item’s low mass supports quick handling and minimal thermal drift during short measurement cycles. Supplied in a protective transport case, the component remains protected during storage and transport, helping to preserve the ground surface and dimensional integrity between uses.

Practical integration into inspection workflows

As an individual gauge pin supplied singularly, the component fits directly into established measuring routines: plug checks, gauge blocks, comparator set‑ups and visual inspection jigs. Classed for fine‑component measurement, the diameter 8.95 mm is suitable for micro‑scale metrology tasks where compact, high‑precision tooling is required. Traceability is supported by the SKU and GTIN data for inventory and quality records, enabling smooth logging in calibration and asset management systems. For adapters or bespoke fixtures, the pin’s standard geometry simplifies mechanical integration.

Contact Metav Werkzeuge for tailored application advice on the M323.895 pin gauge and guidance on integrating it into existing inspection setups — reach our specialists in Emmerich by email at info@metav-werkzeuge.com or by phone on +49 2822 7131930

Technical data

• SKU: M323.895
• GTIN: 4061905061998
• Manufacturer: Metav IndustryLine

Facts

• Diameter: 8.95 mm
• Tolerance: ±0.001 mm
• Length: 50 mm
• Weight: 0.029 kg

Special features

• Material: special steel
• Workshop finish
• Single gauge pin delivery
• Supplied in a protective transport case

FAQ

What tolerance does the pin provide?
The pin gauge M323.895 is specified at ±0.001 mm, making it suitable for micrometric end‑measurements.

What material is used for this gauge pin?
The M323.895 is made from special steel and finished for workshop use to ensure wear resistance and dimensional stability.

Is the pin suitable for deep bores or recessed features?
Yes, the 50 mm usable length offers access into deeper features while preserving stiffness for repeatable contact.

How is the component supplied and protected in transit?
The gauge pin is supplied individually and comes in a protective transport case to maintain the ground surface and prevent handling damage.

Manufacturer / Responsible: Metav Werkzeuge GmbH; Parkring 45; 46446 Emmerich; Germany; +49 2822 7131930; info@metav-werkzeuge.com