11.33mm Gauge Pin 50mm Length Workshop Version, Special Steel - Metav IndustryLine

Combining special steel construction, ±0.002 mm repeatability and a compact 50 mm length, this gauge pin provides reliable end‑measure checks in workshop environments; order via Metav Werkzeuge or consult the specialists if further specification is required.

Gauge pin, single — 11.33 mm Ø, 50 mm length (Workshop version) by Metav IndustryLine

Gauge pin 11.33 mm, 50 mm length is a compact precision end‑measure gauge intended for workshop testing, alignment and dimensional verification of small components

• ±0.002 mm accuracy for repeatable checks
• 11.33 mm diameter suited to fine end‑measure tasks
• 50 mm overall length for compact component access
• Workshop version with transport case for safe handling

Built for repeatable end‑measure checks

The gauge pin is designed for reliable dimensional control where consistent contact geometry is essential. The ±0.002 mm specification denotes the pin’s measured variation under controlled conditions, which translates into tight reproducibility when used for end‑measure inspections or matching plug fits. Constructed from special steel, the pin resists wear typical of workshop use while maintaining its profile, so process deviations are reduced and inspection throughput improves.

Compact format that supports practical workshop workflows

Classified in the micro range (10–100 mm), this compact test gauge offers the ideal balance between reach and stiffness for small parts and assemblies. The 50 mm length and 11.33 mm diameter enable access to confined bores and ends without compromising handling. Supplied as a workshop version and packed in a transport case, the pin is protected during transit and storage, enabling faster deployment on benches or in jigs and minimising downtime caused by damage or loss.

Clear technical fit for quality control tasks

A simple, robust geometry makes the gauge pin suitable for repeat verification tasks, end‑measure control and use as a reference in fixtures. The combination of special steel material and narrow tolerance supports frequent tactile checks and mechanical gauging applications. Where routine verification is required, this format reduces measurement uncertainty and streamlines quality assurance steps, allowing teams to keep production flowing with dependable referencing.

Contact Metav Werkzeuge today for tailored advice on Metav IndustryLine gauge pins, delivery options from Emmerich and assistance matching the component to specific inspection routines — email info@metav-werkzeuge.com or call +49 2822 7131930

Technical data

• Article number: M323.B33
• GTIN: 4061905067747
• Manufacturer: Metav IndustryLine
• Version: Workshop version

Measurements & accuracy

• Diameter: 11.33 mm
• Length: 50 mm
• Weight: 0.10 kg
• Accuracy: ±0.002 mm

Materials & delivery

• Material: special steel
• Delivery: transport case for safe transport
• Intended use: end‑measure checks, workshop testing

FAQ

What is the primary application of this gauge pin?
The gauge pin is intended for end‑measure checks, alignment and dimensional verification of small components in workshop environments.

What tolerance can be expected during routine checks?
The gauge pin is specified with an accuracy of ±0.002 mm, providing close repeatability for inspection and gauging tasks.

Is the gauge pin suitable for confined bores and small parts?
Yes; the 11.33 mm diameter and 50 mm length make this gauge pin well suited to confined bores and compact component checks.

What material is the pin made from and why is that relevant?
Manufactured from special steel, the pin offers wear resistance and stable geometry under typical workshop use, preserving measurement integrity.

How is the pin delivered to protect it during transport?
The workshop version is supplied in a transport case to protect the pin from damage and contamination during handling and transit.

Manufacturer / Responsible: Metav Werkzeuge GmbH; Parkring 45; 46446 Emmerich; Germany; +49 2822 7131930; info@metav-werkzeuge.com