12.4mm Gauge Pin Length 50mm Workshop Version, Special Steel - Metav IndustryLine

Take advantage of the combination of workshop-grade robustness, tight ±0.002 mm tolerance and compact form for reliable end‑measurements; order the test pin directly via Metav Werkzeuge or request consultation for integration into existing gauge sets.

Test pin, single — 12.4 mm diameter, 50 mm length (Metav IndustryLine)

Test pin, single — 12.4 mm diameter, 50 mm length (Metav IndustryLine) is a precision gauge pin intended for workshop inspection, alignment and go/no‑go checking in production environments

• Workshop-grade test pin 12.4 mm
• Length 50 mm for deep checks
• Tolerance ±0.002 mm precision
• Made from special steel

Consistent precision for repeatable checks

The 12.4 mm gauge is machined to a tight ±0.002 mm runout, making it suitable where repeatability is critical in production control. As a single test pin from the Metav IndustryLine, it provides a defined reference for bore checks, fixture alignment and end‑measurements, reducing guesswork during inspection. The nominal tolerance is expressed as a verification limit to support statistical process control and to enable confident decision‑making on part conformity.

Compact format that fits workshop routines

Designed within the Micro measurement class (measurement range up to 100 mm), the compact form factor combines reach and handling ease for routine checks at the bench or on assembly lines. The 50 mm length allows access to moderately deep bores and recesses while keeping the probe rigid under manual use. Its low mass and slim profile make it straightforward to slot into existing gauge stacks or to use as a temporary reference in jigs without impairing ergonomics.

Robust construction and transport-ready delivery

Manufactured from special steel and finished for workshop durability, the pin resists wear in frequent inspection cycles and preserves measurement integrity over time. The single‑piece design reduces stress points and the product is supplied with a protective transport case suitable for secure handling and storage. At approximately 0.1 kg, the gauge balances robustness with convenient portability for service technicians and quality personnel.

Contact Metav Werkzeuge in Emmerich for availability and tailored delivery of the Metav IndustryLine test pin (SKU M323.C40) and advice on integrating this gauge into existing measurement sets

Technical Data

• Article number: M323.C40
• GTIN: 4061905066115
• Manufacturer: Metav IndustryLine
• Category: Measuring pins
• Version: Workshop‑grade

Numbers

• Diameter: 12.4 mm
• Length: 50 mm
• Weight: 0.1 kg
• Tolerance: ±0.002 mm
• ECLASS: 21170231

Special features

• Material: special steel
• Protective transport case included
• Single test pin delivery
• Workshop execution
• SKU: M323.C40
• GTIN provided

FAQ

What is the nominal diameter of this test pin?
The nominal diameter is 12.4 mm as specified for the Test pin, single, 12.4 mm length 50 mm (Metav IndustryLine, SKU M323.C40).

What accuracy can be expected from this gauge pin?
The pin is produced to a tolerance of ±0.002 mm, making it suited to tight workshop and production checks where small deviations matter.

Which applications suit this measuring pin best?
This measuring pin is intended for bore verification, alignment tasks and end‑measurements in machining and assembly environments; its workshop‑grade design supports frequent use.

Is the pin supplied ready for transport and storage?
Yes, the pin is supplied with a protective transport case to safeguard the gauge during handling and transit.

What material is used for the pin construction?
The pin is manufactured from special steel, chosen for wear resistance and dimensional stability under typical workshop conditions.

Manufacturer / Responsible: Metav Werkzeuge GmbH; Parkring 45; 46446 Emmerich; Germany; +49 2822 7131930; info@metav-werkzeuge.com