12.64mm Gauge Pin 50mm Length Workshop Version, Special Steel in Case - Metav IndustryLine

Take advantage of precise repeatability and robust workshop design to reduce setup time and rework. The combination of ±0.002 mm tolerance, special steel construction and transport case delivery supports reliable end‑dimension checks in daily inspection routines — order directly via Metav Werkzeuge for local stock and expert advice.

Gauge pin, single – 12.64 mm × 50 mm (Metav IndustryLine)

A gauge pin, single – 12.64 mm × 50 mm for accurate end‑dimension verification and quick go/no‑go checks in workshop inspection and assembly operations.

• Workshop version for robust daily use
• Diameter 12.64 mm, length 50 mm
• Accuracy ±0.002 mm
• Made from special steel

Repeatable precision for critical tolerances

The single gauge pin delivers high repeatability for measuring end dimensions and verifying bore sizes where tight tolerances matter. With a stated accuracy of ±0.002 mm, the pin is suitable for fine inspection tasks and dimensional checks in production control. The nominal diameter 12.64 mm is ground to a stable reference profile so that successive measurements remain comparable; this reduces the need for frequent recalibration cycles and supports consistent quality decisions on the shop floor. The precision specification is a concrete, rational benefit for manufacturers aiming to limit scrap and avoid assembly mismatches.

Built for workshop handling and long service life

Engineered as a workshop version, the pin combines a compact 50 mm length with a wear‑resistant special steel grade to withstand daily use. The relatively low mass facilitates secure handling and alignment during checks, while the robust material reduces surface wear that would otherwise alter fit over time. The pin is supplied in a protective transport case, easing movement between workplaces and protecting the measuring surface during storage. These construction choices translate into lower lifetime costs and fewer interruptions in inspection workflows.

Practical use cases that speed up production checks

Ideal for quick go/no‑go tests, end‑dimension validation and bore verification, the pin serves both assembly stations and inspection benches. In jigging or finishing operations it provides a reliable reference for end‑mass assessment, helping to confirm whether components meet specified limits before further processing. The straightforward geometry makes the tool easy to integrate into incoming inspection routines or final checks, improving throughput without compromising measurement confidence. For environments that demand robustness and repeatable results, this single gauge pin supports measurable quality improvements.

For reliable end‑dimension control from stock in Emmerich, ask Metav Werkzeuge about the Metav IndustryLine gauge pin M323.C64 and secure professional advice on integrating this pin into inspection workflows.

Technical data

• SKU: M323.C64
• GTIN: 4061905065330
• Brand: Metav IndustryLine

Facts

• Diameter: 12.64 mm
• Length: 50 mm
• Accuracy: ±0.002 mm
• Weight: 0.1 kg

Special features

• Material: special steel
• Workshop version design
• Supplied in transport case
• Suitable for end‑dimension and bore checks

FAQ

What tolerance does this gauge pin offer?
The gauge pin M323.C64 from Metav IndustryLine is specified with an accuracy of ±0.002 mm.

Can the pin be used for go/no‑go verification?
Yes, the single gauge pin is suitable for quick go/no‑go assessments and bore checks as part of routine inspection procedures.

What material is the pin made from?
The pin is manufactured from special steel, chosen for wear resistance and durability in workshop applications.

How should the pin be stored to maintain accuracy?
Store the pin in its protective transport case and avoid contact with abrasive surfaces; periodic cleaning and gentle handling preserve the measuring surface.

Manufacturer / Responsible: Metav Werkzeuge GmbH; Parkring 45; 46446 Emmerich; Germany; +49 2822 7131930; info@metav-werkzeuge.com