13.02mm Gauge Pin Length 50mm, Workshop Version, ±0.002 Accuracy - Metav IndustryLine

Take advantage of the combination of high repeatability, tight tolerance and robust workshop design for dependable inline checks and fixture reference; order the test pin directly via Metav Werkzeuge or consult our technical advisors for application support.

Test pin M323.D02 — single test pin, 13.02 mm diameter, 50 mm length (Metav IndustryLine)

The Test pin M323.D02 serves as a compact, workshop‑grade reference pin for end‑measurement, gauging and alignment tasks in production and inspection environments.

• Workshop design for robust, everyday use
• Diameter 13.02 mm for precise reference fits
• 50 mm overall length for stable engagement
• Accuracy ±0.002 mm for high repeatability

Reliable tolerance control for routine inspection

The gauge pin is specified with an accuracy of ±0.002 mm, enabling fine repeatability in comparative checks and reference measurements. A consistent shaft diameter of 13.02 mm provides a fixed datum for go/no‑go or plug‑gauge procedures and helps to reduce cumulative error when used in stacked jigs or fixtures. The declared tolerance supports tasks where dimensional certainty over many cycles is required, such as batch inspection, incoming part verification and quick component sorting on the shop floor.

Built for workshop handling and stable seating

With an overall length of 50 mm and a mass of approximately 0.10 kg, this single test pin balances handling convenience with stable engagement in housings and bores. The workshop version construction focuses on everyday durability and ease of installation in measurement fixtures; the choice of special steel offers a compromise between wear resistance and machinability appropriate for repeated contact with mating parts. These characteristics reduce the need for frequent replacement and help maintain consistent reference conditions in production environments.

Practical integration into gauging and fixture workflows

The pin functions as a fixed reference in a variety of practical setups: end‑stop checks, alignment pins in assembly jigs, and reference plugs for validators. As a single‑piece reference, it simplifies inventory and replacement logistics and pairs readily with common inspection tools and fixtures. The compact form factor and defined diameter make it suitable for both manual gauging stations and semi‑automated inspection rigs, supporting quick verification without elaborate adjustments.

Request tailored supply advice or a consultation from Metav Werkzeuge for the M323.D02 test pin and ensure the right configuration for your measurement setup at our Emmerich centre

Technical data

• Article number: M323.D02
• GTIN: 4061905067167
• Label: Test pin, single, 13.02 mm length 50 mm
• Manufacturer: Metav IndustryLine

Facts

• Diameter: 13.02 mm
• Length: 50 mm
• Weight: 0.10 kg
• Tolerance / Accuracy: ±0.002 mm

Special features

• Workshop version
• Material: Special steel
• Single test pin design

FAQ

What materials is the pin made from?
The M323.D02 test pin is manufactured from special steel, chosen for workshop durability and reliable contact performance.

How precise is the M323.D02 for repeatable checks?
Measured repeatability is governed by the specified accuracy of ±0.002 mm, making the pin suitable for fine inspection and reference tasks.

Can this pin be used as an alignment reference in fixtures?
Yes — the 13.02 mm diameter and 50 mm length make the pin suitable as a fixed reference or alignment dowel in a wide range of jigs and assembly fixtures.

Manufacturer / Responsible: Metav Werkzeuge GmbH; Parkring 45; 46446 Emmerich; Germany; +49 2822 7131930; info@metav-werkzeuge.com