13.51mm Gauge Pin 50mm Length, Special Steel Workshop Version - Metav IndustryLine

High-precision 13.51 mm diameter, 50 mm length and ±0.002 mm tolerance deliver reproducible end‑measure checks; order the test pin directly via Metav Werkzeuge or ask our consultants if needed

Metav IndustryLine Test pin M323.D51 — single measuring pin, Ø 13.51 mm, length 50 mm

Test pin M323.D51 for verification of bore diameters and end measurements in workshop quality control and inspection tasks

• Workshop design, robust construction
• Precise diameter 13.51 mm
• Length 50 mm for stable handling
• Tolerance ±0.002 mm for fine checks

Consistent, high‑precision dimensional checks

This measuring pin is built for repeatable verification: a nominal diameter of 13.51 mm combined with a measured tolerance of ±0.002 mm minimises uncertainty during go/no‑go and comparative tests. The special steel construction ensures dimensional stability under regular workshop conditions, while the compact 50 mm length provides sufficient engagement for reliable end‑measure readings without excessive overhang. Such specification converts into fewer inspection re‑runs and faster decision cycles on the shop floor.

Robust workshop execution for daily use

Designed as a workshop execution item, the pin balances stiffness and handling comfort. The moderate length and the material choice give a good ratio of mass to grip, with a listed weight supporting steady placement during tactile checks. This construction reduces operator‑induced variation and supports quicker throughput in repetitive inspection tasks, meaning inspection routines remain efficient and traceable across batches and shifts.

Practical integration and replacement capability

Supplied as a single test pin, the item is suitable for direct replacement in modular gauge assemblies or for use as a reference probe in manual inspection jigs. The clear identification and standardised dimensions make it straightforward to document and store as part of an inspection set. For workshop managers seeking consistent metrology across multiple workstations, this measuring pin contributes to harmonised procedures and predictable measurement outcomes.

For reliable bore verification, request the Metav IndustryLine M323.D51 test pin through Metav Werkzeuge — contact our specialists in Emmerich for technical advice and prompt dispatch

Technical data

• Article number: M323.D51
• GTIN: 4061905067013
• Label: Test pin, single, Ø 13.51 mm, length 50 mm

Facts

• Diameter: 13.51 mm
• Length: 50 mm
• Weight: 0.1 kg
• Tolerance: ±0.002 mm

Special features

• Material: special steel
• Workshop execution
• Supplied as a single test pin

FAQ

What is the dimensional tolerance of this test pin?
The Metav IndustryLine M323.D51 test pin is specified with a tolerance of ±0.002 mm for accurate end‑measure and bore verification.

Is this pin suitable for repeat inspections in a production environment?
Yes. The M323.D51 is a workshop‑grade measuring pin made from special steel and designed for repeated use in routine inspection tasks.

Can the pin be used as a replacement in gauge assemblies?
The single‑supply format of the M323.D51 makes it suitable for direct replacement in modular gauge holders and manual inspection fixtures.

What documentation accompanies the product?
The product is supplied with its standard identification details (article number and GTIN) for traceability; any further certification should be requested prior to order if required for specific quality systems.

How does the length influence handling and accuracy?
The 50 mm length provides a balance between engagement depth and rigidity, reducing flex during placement and improving repeatability for end‑measure operations.

Manufacturer / Responsible: Metav Werkzeuge GmbH; Parkring 45; 46446 Emmerich; Germany; +49 2822 7131930; info@metav-werkzeuge.com