13.74mm Gauge Pin, Single, 50mm Length, Workshop Version - Metav IndustryLine

Take advantage of the combination of 13.74 mm diameter, 50 mm length and a tight ±0.002 mm tolerance to secure repeatable end‑size inspections in the workshop; order the gauge pin directly via Metav Werkzeuge or consult our technical team for sizing advice.

M323.D74 gauge pin — 13.74 mm Ø, 50 mm length (Metav IndustryLine)

A M323.D74 gauge pin for precise end‑size inspection and plug checking in precision metrology and workshop quality control.

• Diameter 13.74 mm for end‑size checks
• Length 50 mm workshop version
• Tolerance ±0.002 mm high precision
• Special steel for robust everyday use

Reliable accuracy for routine inspection

The gauge pin delivers consistent dimensional control where repeatability matters. With a nominal diameter of 13.74 mm and a manufacturing tolerance of ±0.002 mm, this inspection pin supports high‑precision checks during incoming inspection, final control or setting tasks. The tight tolerance reduces rework and ambiguous decisions, so process stability and throughput improve without increasing cycle complexity. The compact form factor is optimised for insertion checks and ring or bore verification where a defined end measurement is required.

Workshop design that endures daily use

Built in a workshop execution and manufactured from special steel, the inspection pin is designed for frequent handling and rapid checks at the bench. The 50 mm active length gives a practical contact area while keeping handling simple for single‑handed operations or quick fixture checks. The choice of material and the rugged finish provide durability in standard shop environments, helping to maintain nominal diameter and surface condition over repeated use and ensuring a long service life under typical workshop stresses.

Fits into quality workflows and gauge sets

This inspection pin integrates easily into established quality routines and accessory fixtures. The straightforward geometry makes it suitable for use as a reference plug in gauges, for go/no‑go verification or as a master for visual comparison. Measurable benefits include faster inspection cycles and reduced measurement uncertainty due to the pin’s high repeatability. Documentation of the product specifications simplifies traceability and aids in audit situations, supporting quality management objectives without extra administrative burden.

Contact Metav Werkzeuge for personalised advice on integrating the M323.D74 gauge pin into inspection routines or for assistance selecting matching sizes and holders — Metav Werkzeuge is ready to advise from Emmerich.

Technical data

• Article number: M323.D74
• GTIN: 4061905069819
• Material: special steel
• Net weight: 0.1 kg

Facts

• Diameter: 13.74 mm
• Length: 50 mm
• Tolerance: ±0.002 mm
• Category: single inspection pin

Special features

• Workshop execution
• Story trigger: end‑size inspection
• ECLASS: 21170231

FAQ

What material is the pin made from?
The M323.D74 gauge pin is manufactured from special steel, selected to provide durability and dimensional stability for workshop inspection tasks.

What accuracy can be expected from this inspection pin?
The pin is produced to a tolerance of ±0.002 mm, delivering high precision suitable for reliable end‑size checks and repeatable measurements.

For which applications is the pin intended?
Designed for end‑size inspection, plug checking and use as a reference in gauge sets, the pin is suited to incoming inspection and routine shop checks.

Is the length suitable for fixture use?
The active length of 50 mm offers a practical balance between engagement depth and handling, making it compatible with common fixtures and quick verification routines.

How is the product delivered?
The item is supplied as a single inspection pin, ready for immediate use in workshop quality control and inspection procedures.

Metav IndustryLine: Manufacturer / Responsible: Metav Werkzeuge GmbH; Parkring 45; 46446 Emmerich; Germany; +49 2822 7131930; info@metav-werkzeuge.com