14.73mm Gauge Pin Single 50mm Length Workshop Finish - Metav IndustryLine

Benefit from the combination of ±0.002 mm tolerance, special steel construction and a compact 50 mm length for precise end‑dimension checks; order the test pin directly via Metav Werkzeuge or consult our specialists if required.

Test pin, Ø 14.73 mm — 50 mm length (Metav IndustryLine)

Test pin 14.73 mm for workshop metrology and end‑measurement tasks across inspection fixtures and gauges

• Workshop‑grade construction
• Diameter 14.73 mm precision
• Tolerance ±0.002 mm
• Compact 50 mm overall length

Repeatable precision for end‑dimension inspection

The test pin is manufactured from special steel and finished to a tight ±0.002 mm deviation, providing reliable reference diameters for inspection, fixture set‑up and end‑measurement verification. The small form factor and precise diameter make this probe suitable for alignment checks and plug‑gage tasks where consistent contact geometry is essential. By reducing measurement scatter the component rejection rate falls and process stability improves, delivering clear cost‑efficiency in serial inspection.

Robust workshop design that endures daily use

Engineered as a workshop‑grade item, the probe combines wear‑resistant material selection with a compact 50 mm length to balance stiffness and handling. The relatively short shank limits bending and improves tactile control when fitted into holders or manual fixtures, while the special steel composition resists surface wear under typical workshop conditions. This durability translates into fewer replacements and predictable long‑term performance for routine production checks.

Practical integration in inspection setups

The probe’s defined diameter and short overall length simplify incorporation into go/no‑go fixtures, comparator stands and manual gauging systems. The precise diameter value of 14.73 mm allows repeatable seating in dedicated bushings or threaded adaptors, easing the creation of custom inspection aids. Traceability is supported through the provided SKU and GTIN, enabling inventory control and identification within structured quality systems.

Contact Metav Werkzeuge in Emmerich for specification advice and supply of Metav IndustryLine test pins, and ensure the correct probe configuration for the measurement task at hand

Technical Data

• Article number: M323.E73
• GTIN: 4061905067471
• Manufacturer: Metav IndustryLine

Facts

• Diameter: 14.73 mm
• Length: 50 mm
• Tolerance: ±0.002 mm
• Weight: 0.1 kg
• eClass: 21170231

Special features

• Material: Special steel
• Version: Workshop execution
• Label: Test pin, single, 14.73 mm length 50 mm
• Story trigger: end dimensions

FAQ

What applications is this test pin intended for?
The test pin is intended for end‑dimension checks, fixture set‑up and insert gauges in workshop metrology, where a precise reference diameter is required.

Is the tolerance of ±0.002 mm suitable for production inspection?
Yes, the ±0.002 mm tolerance places this probe in a high‑precision category suited to demanding workshop and inspection tasks; Metav IndustryLine items are selected to support reproducible measurements.

Which material is used and why does it matter?
The pin is made from special steel, chosen for wear resistance and dimensional stability under repeated contact, which preserves measurement reliability over time.

How is the product identified for ordering and inventory?
Order and inventory using SKU M323.E73 and GTIN 4061905067471; these identifiers ensure correct procurement of the Metav IndustryLine test pin.

Manufacturer / Responsible: Metav Werkzeuge GmbH; Parkring 45; 46446 Emmerich; Germany; +49 2822 7131930; info@metav-werkzeuge.com