16.02mm Gauge Pin, Workshop Version, 50mm Length, Special Steel - Metav IndustryLine

Take advantage of a workshop-grade testing solution that combines high repeatability, compact dimensions and robust material selection for reliable end-measure checks; order directly via Metav Werkzeuge or request technical guidance from our consultants for seamless integration into existing inspection routines.

M323.G02 Gauge Pin — Ø 16.02 mm, Length 50 mm (Metav IndustryLine)

The M323.G02 is a single workshop-grade gauge pin designed for precise end-measure verification and fixture checking in production and inspection environments

• Workshop-grade execution for daily use
• Diameter 16.02 mm for end-measure checks
• Tight tolerance ±0.002 mm for reproducible results
• Delivered in a protective case for transport

Consistent reference for end-measure verifications

A compact, single-piece gauge pin that serves as a reliable reference for end-of-line and in-process checks. With a nominal diameter of 16.02 mm and a length of 50 mm, the component provides a stable datum for fixture alignment and plug-type inspections. The specified ±0.002 mm tolerance supports high-precision comparisons and reduces uncertainty in go/no-go assessments. Constructed from special steel, the pin resists deformation under standard workshop handling, helping to preserve dimensional integrity over repeated insertions.

Lower reject rates through reproducible inspection

Integrating this precision pin into a routine inspection sequence increases throughput by shortening verification cycles and reducing secondary checks. The smooth, hardened surface minimises fretting and wear against mating bores, which contributes to long-term dimensional stability. Supplied in a protective case, the item stays transport-safe and ready for immediate use on the shop floor or in a measuring bench, while its compact mass (approx. 0.15 kg) makes manual handling straightforward and safe.

Proven supply chain and workshop suitability

Metav IndustryLine positions this test pin as a dependable workshop tool: robust material choice and exacting manufacturing tolerances make it suitable for fixture set-up, end-measure audits and calibration routines where repeatability matters. The product is traceable via GTIN and shipped from the Metav distribution centre in Emmerich, backed by the company's broad inventory and established logistics. For purchasers seeking consistent measurement references, this gauge pin offers a pragmatic balance of precision, durability and workshop practicality.

Contact Metav Werkzeuge for expert advice on integrating the M323.G02 gauge pin into inspection jigs or fixture setups and to arrange supply from the Emmerich distribution centre

Technical Data

• Article number: M323.G02
• GTIN: 4061905069239
• Manufacturer: Metav IndustryLine

Facts

• Diameter: 16.02 mm
• Length: 50 mm
• Tolerance: ±0.002 mm
• Weight: 0.15 kg

Special features

• Workshop execution
• Material: special steel
• Delivered in a protective case
• Category: gauge pins / test pins

FAQ

What is the intended application of this gauge pin?
The M323.G02 gauge pin from Metav IndustryLine is intended for end-measure verification, fixture alignment and plug-type inspection tasks in workshop and inspection settings.

What level of precision does the pin offer?
Manufactured to a tolerance of ±0.002 mm, the M323.G02 supports high-repeatability checks and is suitable where tight dimensional control is required.

Is the gauge pin suitable for use with assembly fixtures and jigs?
Yes, the robust construction and compact dimensions of the M323.G02 make it well suited for fixture set-up and routine verification in production environments.

Manufacturer / Responsible: Metav Werkzeuge GmbH; Parkring 45; 46446 Emmerich; Germany; +49 2822 7131930; info@metav-werkzeuge.com