16.49mm Gauge Pin, Single, 50mm Length Workshop Version, Special Steel - Metav IndustryLine

Take advantage of a compact inspection pin that combines high repeatability and robust workshop design — ideal for routine end‑dimension checks. With a 16.49 mm nominal diameter, 50 mm length and a fine tolerance of ±0.002 mm, order the pin directly via Metav Werkzeuge or consult our specialists for application advice.

M323.G49 test pin — 16.49 mm Ø, 50 mm length (Metav IndustryLine)

The M323.G49 test pin is a workshop-grade inspection pin intended for precise end‑dimension verification and use as a reference gauge in routine measuring processes.

• High-precision tolerance ±0.002 mm
• Nominal diameter 16.49 mm
• Length 50 mm for depth inspections
• Workshop-grade special steel construction

Repeatable dimensional control for routine inspections

The compact design provides a stable reference for pass/fail checks and comparative measurements. With a specified tolerance of ±0.002 mm, the pin supports tight acceptance criteria while keeping handling straightforward. The combination of nominal diameter 16.49 mm and a 50 mm effective length makes the component suitable for checking bores, plug fits and end‑measurements where a short, rigid gauge is required. This precision supports reduced rework and faster inspection cycles in production environments.

Robust construction that suits workshop conditions

Built as a workshop version, the pin is manufactured from special steel to withstand frequent use and mild impacts typical for shop floors. At approximately 0.15 kg, the component offers good mass for stable seating without being cumbersome during manual inspections. The material choice balances wear resistance and dimensional stability, prolonging service life under standard workshop handling. This durability translates into predictable measurement behaviour and lower replacement frequency.

Practical integration into metrology routines

The pin functions as a straightforward inspection aid for assembly, quality control and incoming inspection tasks. It is compatible with common bench fixtures and can be used alongside micrometers, depth gauges and comparator setups as a reproducible contact surface. For traceable results, record measurements against the pin’s nominal 16.49 mm dimension and stated tolerance; the clear specification aids in documenting conformity during batch checks. The small footprint and familiar geometry make it a convenient addition to any metrology kit.

Choose the Metav IndustryLine M323.G49 when consistent, workshop-ready reference measurements are needed — contact Metav Werkzeuge for technical guidance and prompt supply from Emmerich.

Technical data

• SKU: M323.G49
• GTIN: 4061905068539
• Article: Test pin, single, 16.49 mm diameter, length 50 mm
• Manufacturer: Metav IndustryLine

Core specifications

• Diameter: 16.49 mm
• Length: 50 mm
• Tolerance: ±0.002 mm
• Weight: 0.15 kg

Features

• Workshop version
• Material: special steel
• Category: Measuring pins

FAQ

What inspection tasks is this pin suited for? The M323.G49 test pin is designed for end‑dimension checks, plug fits and short‑range bore verification in workshop and production inspection routines.

Does the pin come calibrated to a national standard? The supplied data does not specify a calibration certificate; the M323.G49 is specified with its nominal dimension and tolerance for immediate use in routine checks.

Is the material suitable for frequent contact use? Yes, the pin is made from special steel and the workshop‑grade design is intended for repeated handling and standard inspection wear.

Manufacturer / Responsible: Metav Werkzeuge GmbH; Parkring 45; 46446 Emmerich; Germany; +49 2822 7131930; info@metav-werkzeuge.com