16.6mm Gauge Pin 50mm Length Workshop Version, Special Steel - Metav IndustryLine

Take advantage of the combination of workshop‑grade robustness, ±0.002 mm dimensional accuracy and a compact 50 mm length for repeatable end‑measurement checks; order the gauge pin directly via Metav Werkzeuge or contact our consultants for application advice.

Gauge pin M323.G60 (single) – Ø 16.6 mm, 50 mm length, Metav IndustryLine

A gauge pin M323.G60 engineered for precise end‑measurements and routine inspection tasks in workshop and production environments

• Workshop version for robust handling
• Precision tolerance ±0.002 mm
• Special steel, hardened for wear resistance

High precision for decisive inspection results

The single measuring pin delivers a tolerance of ±0.002 mm, which establishes it as a reliable reference for tight fit checks and end‑measurement tasks. This level of accuracy reduces uncertainty in pass/fail evaluations and supports consistent assembly outcomes. The nominal diameter Ø 16.6 mm is manufactured to tight limits so that repeat measurements remain comparable; in practice this means fewer reworks and clearer go/no‑go decisions at the inspection stage.

Built to withstand workshop routines

Constructed from special steel, this workshop configuration resists wear during frequent use and maintains contact geometry over time. The compact 50 mm length provides a stable, easy‑to‑handle measuring element that fits standard bench fixtures and quick‑check stations. Supplied in a protective transport box, the pin stays organised and protected in transit or on the shop floor, simplifying storage and reducing the risk of damage between shifts.

Practical use and handling benefits

Designed for routine end‑measurements, the gauge pin is suitable for verifying bore sizes, checking alignment and validating mating parts in small‑batch production. The moderate mass supports steady hand placement while remaining light enough for repeated manual checks; the construction supports quick introduction into pre‑existing fixtures and measuring rigs. The single design and workshop finish mean dependable performance where clarity and repeatability are essential—ideal for production inspectors and toolroom technicians seeking a robust reference pin.

Contact Metav Werkzeuge for tailored advice or to arrange supply from our Emmerich warehouse; technical consultants are available to confirm fit and application for Metav IndustryLine products

Technical data

• Article number: M323.G60
• GTIN: 4061905070426
• Label: Gauge pin, single, 16.6 mm, length 50 mm

Facts

• Nominal diameter: 16.6 mm
• Length: 50 mm
• Tolerance / accuracy: ±0.002 mm
• Weight: 0.15 kg

Special features

• Workshop version
• Material: Special steel
• Supplied in a protective transport box
• Application focus: end measurements
• eClass: 21170231

FAQ

What is the dimensional tolerance of this gauge pin?
The gauge pin M323.G60 offers a dimensional tolerance of ±0.002 mm, making it suitable for precision end‑measurement tasks in workshop and inspection settings.

What material is used for the pin?
This Metav IndustryLine gauge pin is made from special steel, selected for wear resistance and stability under frequent contact use.

Is the pin delivered ready for storage and transport?
Yes, the pin is supplied in a protective transport box to keep the measuring face and shaft secure during storage and transit.

For which inspection tasks is this pin suitable?
The M323.G60 single gauge pin is intended for end‑measurements such as bore checking, alignment verification and plug‑type fit assessments in routine production controls.

Manufacturer / Responsible: Metav Werkzeuge GmbH; Parkring 45; 46446 Emmerich; Germany; +49 2822 7131930; info@metav-werkzeuge.com