16.73mm Gauge Pin 50mm Length Workshop Version, Special Steel - Metav IndustryLine

Take advantage of a combination of high dimensional accuracy (±0.002 mm), a workshop‑grade special‑steel construction and compact handling for reliable process checks — ideal where repeatable reference measurements are required. Order the gauge pin directly via Metav Werkzeuge or request further information from our consultants.

Gauge pin M323.G73 — single test pin, 16.73 mm Ø, 50 mm length (Metav IndustryLine)

A gauge pin designed as a workshop‑grade reference and go/no‑go aid for inspection and assembly tasks in industrial metrology.

• Single gauge pin, diameter 16.73 mm, length 50 mm
• Workshop-grade special steel construction
• Dimensional tolerance ±0.002 mm for fine precision
• Supplied in protective transport case

Repeatable reference measurements with micrometre‑level accuracy

This test pin delivers a concise metrological basis for routine inspection and reference tasks. The specified tolerance of ±0.002 mm supports precise pass/fail checks and dimensional comparisons where small deviations matter; this level of accuracy is suitable for quality control tasks that demand consistent, repeatable results. By referencing a stable diameter rather than relying on temporary setups, process variability is reduced and measurement throughput is improved. The hard‑wearing geometry maintains form under repeated seating, so inspection cycles remain predictable.

Durable workshop design for daily use

Constructed from special steel, the pin is tailored to withstand the knocks and handling of a busy shop floor while keeping its measuring surface intact. The compact form factor — 16.73 mm diameter and 50 mm length — provides a balance between reach and rigidity, simplifying insertion into bores or jig features without flexing. Supplied in a protective transport case, the item is delivered ready for safe storage and transfer between workstations. The robust finish aids corrosion resistance and prolongs service life, which reduces replacement frequency and supports continuous operation.

Practical integration into inspection and assembly workflows

As a single test pin, the component is straightforward to deploy for assembly verification, fixture setting, and dimensional control on the production line. The compact mass and consistent geometry make it suitable for slotting into existing inspection fixtures or for use as a tactile reference in manual checks. Identification is clear through the item code M323.G73, which streamlines ordering and stock management. Where traceable calibration or certificates are required, additional services are available from Metav Werkzeuge to match enterprise traceability needs.

Contact Metav Werkzeuge for procurement assurance and reliable supply from Emmerich — request item M323.G73 from our consultants via info@metav-werkzeuge.com or by phone on +49 2822 7131930

Technical data

• Article number: M323.G73
• GTIN: 4061905071898
• Label: Prüfstift, einzeln, 16,73 mm Länge 50 mm

Key figures

• Diameter: 16.73 mm
• Length: 50 mm
• Weight: 0.15 kg
• Dimensional tolerance: ±0.002 mm

Special features

• Workshop‑version construction
• Material: special steel
• Supplied in transport case
• Single gauge/test pin

FAQ

What is the material of the pin and how robust is it?
The pin is made from special steel and the workshop‑grade construction is intended for regular use in inspection and assembly environments.

What accuracy can be expected during routine checks?
The item is manufactured to a dimensional tolerance of ±0.002 mm, allowing fine precision for pass/fail and reference measurements.

Is the pin suitable for use in bore gauging and fixture alignment?
Yes — the diameter and length combination provides a stable reference for bore checking, fixture setup and tactile alignment tasks.

How can the part be identified for reordering?
Reorder using the article number M323.G73 and GTIN 4061905071898 for clear identification.

Manufacturer / Responsible: Metav Werkzeuge GmbH; Parkring 45; 46446 Emmerich; Germany; +49 2822 7131930; info@metav-werkzeuge.com