17.12mm Gauge Pin Length 50mm, Workshop Finish, Special Steel ±0.002mm - Metav IndustryLine

Take advantage of the combination of ±0.002 mm repeatability, a precisely ground 17.12 mm diameter and the compact 50 mm length for reliable reference measurements in busy workshops; the robust special steel construction and workshop design support long service life. Purchase or request advice via Metav Werkzeuge for application support and supply.

Test pin M323.H12 – Gauge pin, Ø 17.12 mm, 50 mm length (Metav IndustryLine)

A Test pin (M323.H12) designed as a workshop-grade gauge pin for end-measure and reference inspections across production and quality workflows.

• High precision ±0.002 mm
• Diameter 17.12 mm ground to tolerance
• 50 mm length for compact fixtures
• Workshop version for robust use

Consistent accuracy to speed inspections

The M323.H12 is built to deliver consistent, repeatable measurements thanks to its specified accuracy of ±0.002 mm, which reduces uncertainty in limit checks and comparative gauging. A precisely ground 17.12 mm diameter provides a defined reference surface for end-mass and plug-style inspections; when used as a reference pin in jigs or fixture setups, the reduced need for post-adjustment shortens cycle times and increases throughput without sacrificing measurement confidence.

Robust design for workshop environments

Manufactured from special steel and specified as a workshop version, this gauge pin balances wear resistance with handling robustness. The compact 50 mm length keeps the pin stiff in confined setups and simplifies insertion into tight bores or alignment fixtures. Supplied in a transport case (plastic or wooden, depending on size and logistics), the unit arrives protected for storage and transit, helping to maintain surface integrity and the calibrated condition of the reference face during routine handling.

Practical applications and integration benefits

As a ground gauge pin, the component serves in end-measure checks, assembly controls and comparator fixtures where a precisely defined diameter is required. The modest weight and compact form factor make it suitable for bench metrology, workshop inspection stations and small-series quality control rigs. Where traceability or special documentation is required, specify these needs when enquiring; the pin itself integrates readily into existing verification routines and fixture layouts to standardise pass/fail evaluations.

Contact Metav Werkzeuge to discuss how the M323.H12 test pin fits specific inspection setups and to arrange supply from Metav IndustryLine.

Technical data

• Article number: M323.H12
• SKU: M323.H12
• GTIN: 4061905070716
• Label: Test pin, single, 17.12 mm length 50 mm

Key measurements

• Diameter: 17.12 mm
• Length: 50 mm
• Accuracy: ±0.002 mm
• Weight: 0.15 kg

Materials & features

• Material: special steel
• Workshop version
• Supplied in transport case (plastic or wooden)
• Category: Gauge pins (Messstifte)

FAQ

What tolerance does this gauge pin provide?
The M323.H12 test pin is specified with an accuracy of ±0.002 mm, suitable for tight reference and limit-measure tasks.

Is the pin intended for workshop use?
Yes, the item is described as a workshop version and is made from special steel for robust everyday use.

Is a calibration certificate included with the product?
No specific calibration certificate is listed in the product data; calibration status is not specified and should be confirmed if required.

Which applications are typical for this gauge pin?
Typical uses include end-measure checks, reference plugs in fixtures, comparator setups and small-series quality control where a precise reference diameter is required.

Manufacturer / Responsible: Metav Werkzeuge GmbH; Parkring 45; 46446 Emmerich; Germany; +49 2822 7131930; info@metav-werkzeuge.com