17.18mm Gauge Pin Length 50mm Workshop Finish, Special Steel - Metav IndustryLine

Take advantage of the combination of workshop-grade robustness, a precise 17.18 mm nominal diameter and a tight ±0.002 mm tolerance for repeatable end‑measure checks; order the gauge pin directly via Metav Werkzeuge or consult our specialists for application advice.

Precision gauge pin M323.H18 — 17.18 mm diameter, 50 mm length (Metav IndustryLine)

The Precision gauge pin M323.H18 is a single test pin for accurate end‑measure verification and fixture alignment in workshop metrology, engineered for routine use and repeatable results.

• Workshop version for everyday industrial use
• Ø 17.18 mm nominal diameter
• 50 mm overall length for fixture checks
• Tolerance ±0.002 mm for high precision

Reliable measurement where it matters

The gauge pin delivers a consistently tight tolerance of ±0.002 mm, which translates into measurable reliability during set‑up and inspection tasks. Made for the shop floor, this test pin supports quick verification of bores and mating features: the nominal 17.18 mm diameter provides a stable reference, while the 50 mm length ensures sufficient engagement for many fixture and clamp geometries. By converting a dimensional specification into a reproducible physical reference, this component reduces rework and shortens set‑up time.

Robust construction for workshop environments

Manufactured from special steel, the component is finished as a workshop version to withstand regular handling and routine measurement cycles. The material choice maintains a wear‑resistant surface and preserves concentricity over repeated insertions. Delivered in a protective transport case, the pin arrives ready for storage and safe transit between inspection points, preventing damage and preserving the calibrated condition of the reference surface.

Practical benefits for production and quality control

Integrating this precision pin into inspection jigs or go/no‑go routines simplifies decision making: the defined diameter and tolerance enable clear pass/fail checks and support traceable set‑ups. The compact single‑piece design minimises handling complexity and speeds up gauging operations in medium‑volume production. For workshops seeking to stabilise process control with minimal investment, the pin offers an economical route to consistent measurements and reduced downtime.

For supply and technical matching of Metav IndustryLine's M323.H18, contact Metav Werkzeuge for direct ordering and installation guidance

Technical data

• SKU: M323.H18
• GTIN: 4061905070778
• Label: Precision gauge pin, single, 17.18 mm, length 50 mm
• Manufacturer: Metav IndustryLine

Facts

• Nominal diameter: 17.18 mm
• Overall length: 50 mm
• Weight: 0.15 kg
• Tolerance / accuracy: ±0.002 mm

Special features

• Material: special steel
• Workshop version
• Delivered in transport case
• Single test pin for end‑measure checks

FAQ

What is the nominal diameter and length of this gauge pin?
The gauge pin has a nominal diameter of 17.18 mm and an overall length of 50 mm; these are the defining dimensions of the M323.H18.

Is the M323.H18 suitable for routine workshop inspection?
Yes. The M323.H18 is supplied in a workshop version made from special steel and packaged in a transport case for secure handling during everyday inspection tasks.

What accuracy can be expected from this test pin?
The test pin is specified with an accuracy of ±0.002 mm, enabling fine positional and end‑measure checks suited to production and quality control workflows.

Can the gauge pin be used in fixture set‑up and go/no‑go checks?
Absolutely. Its single‑piece design and precise nominal diameter make the pin suitable as a reference for fixture alignment and simple go/no‑go gauging routines.

Manufacturer / Responsible: Metav Werkzeuge GmbH; Parkring 45; 46446 Emmerich; Germany; +49 2822 7131930; info@metav-werkzeuge.com