17.19mm Gauge Pin Single 50mm Length Workshop Version - Metav IndustryLine

Benefit from precise end‑measurement capability combined with robust special‑steel construction and a compact 50 mm body for measurements in confined assemblies. Order the test pin directly via Metav Werkzeuge or consult our specialists for application advice.

M323.H19 test pin — 17.19 mm diameter, 50 mm length (Metav IndustryLine)

The M323.H19 test pin is a workshop‑grade, single precision probe engineered for reliable end‑measurements in compact components and assembly fixtures.

• Workshop‑grade special‑steel construction
• Precise 17.19 mm diameter
• 50 mm length for confined or recessed measurements

Accuracy that keeps production on target

This probe delivers a consistently low measurement deviation with a declared tolerance of ±0.002 mm, making it suitable for fine end‑dimension checks and quality control operations where small deviations matter. The 17.19 mm nominal diameter is ground to high fidelity and combined with the hardened special steel body this results in repeatable seating against datum faces and gauges. The obvious benefit is fewer scrapped parts and shorter inspection cycles when integrated into routine checks or fixture verification.

Compact form for machines and tight spaces

With an overall length of 50 mm and a compact shaft, the component is classified within the Mikro range for calipers and inspection probes, offering the best balance between reach and rigidity for small assemblies. The short form factor reduces bending and improves handling in confined bores or recessed surfaces, so end‑measurements on housings, sleeves or precision dowels can be completed without ancillary extensions. The compact design also simplifies storage and transport within workshop tool sets.

Built for workshop use and straightforward handling

The workshop execution is reflected in the choice of special steel and a practical overall mass that supports stable manual placement. Supplied in a transport box, the pin is protected during storage and transit and is ready to be integrated into gauge blocks, test fixtures or comparative setups. The robust construction reduces the need for frequent replacements, while the clear numerical tolerance supports traceable inspection protocols and consistent results across production runs.

For repeatable end‑measurements choose the Metav IndustryLine M323.H19 test pin — contact Metav Werkzeuge in Emmerich for procurement or technical clarification: info@metav-werkzeuge.com / +49 2822 7131930

Technical data

• SKU: M323.H19
• GTIN: 4061905071478
• Manufacturer: Metav IndustryLine

Facts

• Diameter: 17.19 mm
• Length: 50 mm
• Weight: 0.15 kg
• Tolerance: ±0.002 mm

Special features

• Material: Special steel
• Design: Workshop execution
• Delivery: Supplied in transport box
• Category: Messstifte
• Application: End measurements

FAQ

What level of accuracy does this test pin provide?
The M323.H19 test pin is specified with a tolerance of ±0.002 mm, suitable for fine end‑dimension checks in precision workshops.

Is the pin suitable for confined bores and recessed measurements?
Yes, the 50 mm overall length and compact shaft geometry make the probe appropriate for confined or recessed measurement situations.

What material is the probe made from and why does that matter?
The probe is manufactured from special steel, providing hardness and wear resistance for repeated contact with datum faces in a workshop environment.

How is the product delivered and protected during transport?
The probe is supplied in a transport box to protect the finished surfaces and maintain measurement integrity until installation.

Can the test pin be used in fixture or gauge applications?
The M323.H19 probe is suited to fixture and gauge use where precise end measurements and repeatability are required

Manufacturer / Responsible: Metav Werkzeuge GmbH; Parkring 45; 46446 Emmerich; Germany; +49 2822 7131930; info@metav-werkzeuge.com