17.42mm Gauge Pin Length 50mm Workshop Finish - Metav IndustryLine

Take advantage of precision, robust workshop design and traceable identification to keep dimensional checks efficient and reproducible; the combination of ±0.002 mm tolerance, 17.42 mm nominal diameter and compact 50 mm length supports reliable end‑measure verification — request the part via Metav Werkzeuge or consult the technical team for application advice.

Gauge Pin M323.H42 — 17.42 mm, 50 mm Length (Metav IndustryLine)

Gauge Pin M323.H42 is a single precision gauge pin designed for end‑dimension verification in workshop inspection and fixture checks.

• Workshop-grade finish
• Diameter 17.42 mm for end-size checks
• Tolerance ±0.002 mm accuracy
• 50 mm special-steel construction

Ensure reproducible size control on the production line

High repeatability in dimensional inspection reduces rework and streamlines quality gates. The 17.42 mm nominal diameter combined with a declared ±0.002 mm tolerance provides a tight acceptance criterion that is suitable for close‑tolerance fits and final inspection. As a hardened inspection pin alternative, this type of gauge is used for quick pass/fail verification of bores, seats and end dimensions; calibrated master gauges and systematic use of a reference set raise overall measurement confidence. The compact form factor allows installation in gauges and fixtures where a stable reference is required without excess overhang.

Durable workshop design for frequent handling

Built in a workshop version finish from special steel, the pin is dimensionally stable and resistant to the knocks and handling typical in everyday inspection routines. The 50 mm length provides sufficient engagement for end‑measure checks while remaining easy to manipulate and mount in test fixtures. Low mass and compact geometry support fast tool changes and simple storage in dedicated holders. The construction focuses on robustness and serviceability rather than decorative finishes, making it a practical choice for maintenance, assembly and quality control stations.

Integrates with inspection processes and traceability systems

Marked with SKU M323.H42 and full GTIN identification, the pin can be recorded in inventory and inspection logs to support traceability. Its single‑piece configuration simplifies fixture design and reduces setup errors when verifying end dimensions during batch runs. Where serial documentation is required, this gauge can be referenced in inspection protocols and work instructions to ensure consistent acceptance criteria across shifts. For users needing confirmation of specification compliance, the clear numerical tolerance and nominal size make the component straightforward to incorporate into quality plans and measurement reports.

For technical selection or to request the M323.H42 gauge pin from Metav IndustryLine, contact Metav Werkzeuge for specification guidance and delivery options at info@metav-werkzeuge.com or by phone on +49 2822 7131930 — our technical consultants are available to advise on integration into existing inspection routines.

Technical data

• Article number: M323.H42
• GTIN: 4061905069994
• Label: Gauge pin, single, 17.42 mm, length 50 mm
• ECLASS: 21170231

Facts

• Diameter: 17.42 mm
• Length: 50 mm
• Weight: 0.15 kg
• Tolerance: ±0.002 mm

Special features

• Material: special steel
• Version: workshop execution
• Category: gauge pins
• SKU: M323.H42

FAQ

What tolerance does the gauge pin provide?
The M323.H42 gauge pin from Metav IndustryLine is specified with a tolerance of ±0.002 mm, making it suitable for tight end‑dimension verifications.

For which inspection tasks is this pin intended?
This single gauge pin is intended for end‑size and bore checks, seating verification and fixture reference tasks where a 17.42 mm nominal plug is required.

What material and finish does the pin have?
The pin is manufactured from special steel with a workshop execution finish designed for robust everyday handling.

Manufacturer / Responsible: Metav Werkzeuge GmbH; Parkring 45; 46446 Emmerich; Germany; +49 2822 7131930; info@metav-werkzeuge.com