19.36mm Gauge Pin 50mm Length Workshop Version, Special Steel - Metav IndustryLine

Precise small-bore inspection is ensured by the combination of a 19.36 mm diameter, 50 mm length and a high repeatability of ±0.002 mm; order the gauge pin directly via Metav Werkzeuge or ask our consultants if needed

Gauge pin M323.J36 — workshop-grade single test pin, 19.36 mm diameter, 50 mm length (Metav IndustryLine)

Gauge pin M323.J36 for end-measure checks and dimensional validation in precision workshops

• Workshop-grade construction for robust use
• Diameter exactly 19.36 mm for tight bore checks
• Length 50 mm for stable, repeatable handling
• High repeatability with ±0.002 mm tolerance

Reliable check for small bores and fittings

The M323.J36 is a gauge pin engineered for consistent end‑measurement of small diameters. With a nominal diameter of 19.36 mm and a 50 mm length the pin provides a stable contact surface that minimises bending and measurement error during manual inspections. The specified ±0.002 mm repeatability supports tight tolerances commonly required in precision engineering and toolmaking, enabling direct verification of bores, dowel seats and alignment features without the need for complex fixtures.

Material choice and workshop suitability

Manufactured from special steel, this workshop version is adapted to frequent handling and quick checks on the shop floor. The material selection balances surface hardness and resistance to wear, helping to maintain the gauge diameter under repeated use. As a single test pin in a workshop execution, it fits into bench inspection routines and quick pass/fail checks; the solid construction reduces the risk of deformation compared with lighter, non‑industrial pins.

Practical benefits for metrology workflows

Using a dedicated measurement pin speeds up routine quality control: the solid geometry simplifies seating in bores, the consistent contact face improves repeatability, and the compact form factor makes the item easy to store on inspection trays. Classified in the Micro category (measuring range up to 100 mm), the component is particularly suitable for fine mechanical work such as micro‑assemblies, small housings and precision dowel verification where both reach and rigidity matter.

Integration into inspection and assembly processes

The pin is intended as a precision reference for end measurements and set‑up operations. Its nominal diameter and tight tolerance mean it can be used to verify nominal bore sizes or act as a control mandrel during assembly. Where traceable, certified gauges are required, Metav Werkzeuge can advise on matching reference standards and complementary measuring tools to complete a coherent inspection routine.

For reliable small-bore inspection with Metav IndustryLine precision, contact Metav Werkzeuge in Emmerich for technical matching and supply advice

Technical data

• Article number: M323.J36
• GTIN: 4061905449512
• Designation: Gauge pin, single, 19.36 mm, length 50 mm
• Brand: Metav IndustryLine

Facts

• Diameter: 19.36 mm
• Length: 50 mm
• Repeatability / tolerance: ±0.002 mm
• Weight: 0.2 kg

Special features

• Material: special steel
• Design: workshop-grade single test pin
• Application: end-measure checks / bore verification
• Category: Micro (measuring range up to 100 mm)

FAQ

What is the intended use of this gauge pin?
The gauge pin M323.J36 is designed for end‑measurement and bore verification in precision workshop environments, suitable for small bores and alignment checks.

Can the M323.J36 be used for serial inspection tasks?
Yes, the workshop‑grade design and ±0.002 mm repeatability make the M323.J36 suitable for repeated quality control tasks and setup procedures.

What material is the pin made from and why does that matter?
The pin is made from special steel, chosen to provide durability and dimensional stability under frequent handling during inspection and assembly.

Manufacturer / Responsible: Metav Werkzeuge GmbH; Parkring 45; 46446 Emmerich; Germany; +49 2822 7131930; info@metav-werkzeuge.com