4.5mm Limit Plug Gauge Wear Allowance On Good Side, DIN 7162 - Filetta
Product information "4.5mm Limit Plug Gauge Wear Allowance On Good Side, DIN 7162 - Filetta"
Reliable DIN 7162 conformity and hardened steel construction give reproducible go/no-go checks; the built-in wear allowance on the good side extends service life. Take advantage of precise inspection, simple handling and long-term durability — order directly via Metav Werkzeuge or consult our specialists for tailored advice.
Limit gauge pin MS911.207 — hardened steel, DIN 7162 (Ø 4.5 mm)
The Limit gauge pin is a hardened-steel inspection pin designed for rapid go/no-go verification in workshop and production environments.
- Hardened steel construction, DIN 7162 compliant
- Diameter 4.5 mm for accurate limit checks
- Wear allowance on the good side to extend life
- Compact design for bench and fixture inspection
Repeatable checks for fast quality decisions
The limit gauge pin MS911.207 provides a straightforward method for pass/fail inspection that reduces decision time on the shop floor. Manufactured to DIN 7162, the pin’s hardened steel body maintains dimensional stability during repeated engagement, which supports consistent repeatability of go/no-go results. Using a simple plug-style verification avoids time-consuming measuring steps, improving throughput and lowering the cost of quality control across batches.
Longer service life with controlled wear
A decisive benefit of this inspection pin is the wear allowance on the good side, which compensates for material loss at the contact surface and preserves the calibrated function of the gauge for longer. The hardened finish resists surface damage while the allowance provides a controlled end-of-life margin, making maintenance planning predictable. This combination of durability and planned wear supports lower replacement frequency and steadier measurement confidence in production environments.
Practical integration into standard inspection workflows
Compact and purpose-built, the pin is suitable for quick checks in assembly, jig inspection and incoming goods control where clear go/no-go outcomes are required. The Ø 4.5 mm size fits small bores and fixture interfaces without complex setup, allowing inspectors to focus on throughput rather than instrument adjustment. The straightforward geometry and compliance with recognised standards make the pin an efficient addition to regulated inspection procedures and routine quality checks.
Choose the Filetta limit gauge pin for DIN 7162-compliant checks and contact Metav Werkzeuge for fast delivery from Emmerich or expert advice at info@metav-werkzeuge.com or +49 2822 7131930
Technical data
- Article number: MS911.207
- Name: Limit gauge pin
- Brand: Filetta
- Standard: DIN 7162
Key measurements
- Diameter: 4.5 mm
Materials & special features
- Material: hardened steel
- Special feature: wear allowance on the good side
- Application: go/no-go inspection and limit checking
FAQ
What standard does this gauge pin follow?
The Filetta limit gauge pin MS911.207 is manufactured to DIN 7162, ensuring conformity with widely recognised inspection practices.
Which material is used for the pin and why does it matter?
The pin is made from hardened steel, chosen for its resistance to wear and ability to retain dimensional stability under repeated use.
How does the wear allowance affect inspection intervals?
The wear allowance on the good side provides a predefined material margin, allowing predictable replacement scheduling and extending usable service life before a new gauge is required.
For which inspection tasks is this pin intended?
It is intended for rapid go/no-go verification of small bores and fixture interfaces, making it suitable for bench checks, assembly control and routine production inspections.
Is the pin suitable for automated fixtures or only manual checks?
Its compact, standard geometry allows use in manual inspection and integration into simple fixtures; suitability for automation depends on fixture design and handling requirements.
Manufacturer / Responsible: Schut Geometrische Meettechniek bv; Duinkerkenstraat 21; 9723 BN Groningen; The Netherlands; +31 50 5877877; schutnl@schut.com